enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Motor control center - Wikipedia

   en.wikipedia.org/wiki/Motor_control_center

   A motor control center (MCC) is an assembly to control some or all electric motors in a central location. It consists of multiple enclosed sections having a common power bus and with each section containing a combination starter, which in turn consists of motor starter , fuses or circuit breaker , and power disconnect . [ 1 ]

3. Control panel (engineering) - Wikipedia

   en.wikipedia.org/wiki/Control_panel_(engineering)

   A control panel is a flat, often vertical, area where control or monitoring instruments are displayed or it is an enclosed unit that is the part of a system [1] that users can access, such as the control panel of a security system (also called control unit).

4. Electrohydraulic servo valve - Wikipedia

   en.wikipedia.org/wiki/Electrohydraulic_servo_valve

   The mechanical feedback has been replaced by an electric feedback with a position transducer. Integrated electronics close the position loop for the spool. These valves are suitable for electrohydraulic position, velocity, pressure or force control systems with extremely high dynamic response requirements.

5. Control system - Wikipedia

   en.wikipedia.org/wiki/Control_system

   The control action is the switching on/off of the boiler, but the controlled variable should be the building temperature, but is not because this is open-loop control of the boiler, which does not give closed-loop control of the temperature. In closed loop control, the control action from the controller is dependent on the process output.

6. Centrifugal pump - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_pump

   Magnetically coupled pumps, or magnetic drive pumps, vary from the traditional pumping style, as the motor is coupled to the pump by magnetic means rather than by a direct mechanical shaft. The pump works via a drive magnet, 'driving' the pump rotor, which is magnetically coupled to the primary shaft driven by the motor. [ 8 ]

7. Engine control unit - Wikipedia

   en.wikipedia.org/wiki/Engine_control_unit

   The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...