Search results
Results from the WOW.Com Content Network
The Interrupt flag (IF) is a flag bit in the CPU's FLAGS register, which determines whether or not the (CPU) will respond immediately to maskable hardware interrupts. [1] If the flag is set to 1 maskable interrupts are enabled. If reset (set to 0) such interrupts will be disabled until
On uni-processor systems, the simplest solution to achieve mutual exclusion is to disable interrupts during a process's critical section. This will prevent any interrupt service routines from running (effectively preventing a process from being preempted). Although this solution is effective, it leads to many problems.
The IRR specifies which interrupts are pending acknowledgement, and is typically a symbolic register which can not be directly accessed. The ISR register specifies which interrupts have been acknowledged, but are still waiting for an end of interrupt (EOI). The IMR specifies which interrupts are to be ignored and not acknowledged.
If set, enables support for the virtual interrupt flag (VIF) in virtual-8086 mode. 1: PVI: Protected-mode Virtual Interrupts: If set, enables support for the virtual interrupt flag (VIF) in protected mode. 2: TSD: Time Stamp Disable: If set, RDTSC instruction can only be executed when in ring 0, otherwise RDTSC can be used at any privilege ...
With regard to SPARC, the non-maskable interrupt (NMI), despite having the highest priority among interrupts, can be prevented from occurring through the use of an interrupt mask. [1] An NMI is often used when response time is critical or when an interrupt should never be disabled during normal system operation.
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
1. Open the Windows Control Panel. 2. Click Programs.. 3. Click DataMask by AOL. 4. Click Change/Remove, Add/Remove, or Uninstall. - If there is no entry in the Add/Remove Programs window for DataMask by AOL, contact our technical support team at datamaskhelp@aol.com.
Conditional branch instructions test this encoded as a four bit value, with each bit representing a test of one of the four condition code values, 2 3 + 2 2 + 2 1 + 2 0. (Since IBM uses big-endian bit numbering, mask value 8 selects code 0, mask value 4 selects code 1, mask value 2 selects code 2, and mask value 1 selects code 3.)