Ad
related to: calculate the area of vent free
Search results
Results from the WOW.Com Content Network
The above equations calculate the steady state mass flow rate for the pressure and temperature existing in the upstream pressure source. If the gas is being released from a closed high-pressure vessel, the above steady state equations may be used to approximate the initial mass flow rate. Subsequently, the mass flow rate decreases during the ...
In a nozzle or other constriction, the discharge coefficient (also known as coefficient of discharge or efflux coefficient) is the ratio of the actual discharge to the ideal discharge, [1] i.e., the ratio of the mass flow rate at the discharge end of the nozzle to that of an ideal nozzle which expands an identical working fluid from the same initial conditions to the same exit pressures.
= cross-sectional area of opening, ft² (assumes equal area for inlet and outlet) C d = Discharge coefficient for opening (typical value is 0.65) g = gravitational acceleration, around 32.2 ft/s² on Earth H d = Height from midpoint of lower opening to midpoint of upper opening, ft T I = Average indoor temperature between the inlet and outlet ...
The amount of ventilation in an ETS area is equal to the amount of an ETS-free area plus the amount V, where: V = DSD × VA × A/60E V = recommended extra flow rate in CFM (L/s) DSD = design smoking density (estimated number of cigarettes smoked per hour per unit area) VA = volume of ventilation air per cigarette for the room being designed (ft ...
However, they are seldom used as the actual basis of design or calculation. For example, residential ventilation rates are calculated based on area of the residence and number of occupants. [5] Non-residential ventilation rates are based on floor area and number of occupants, or a calculated dilution of known contaminants. [6]
For buildings with one or two floors, h is the height of the building and A is the flow area of the openings. For multi-floor, high-rise buildings, A is the flow area of the openings and h is the distance from the openings at the neutral pressure level (NPL) of the building to either the topmost openings or the lowest openings.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
In general, compliance is defined by the change in volume (ΔV) versus the associated change in pressure (ΔP), or ΔV/ΔP: = During mechanical ventilation, compliance is influenced by three main physiologic factors:
Ad
related to: calculate the area of vent free