Search results
Results from the WOW.Com Content Network
A septic drain field, a septic tank, and associated piping compose a septic system. The drain field typically consists of an arrangement of trenches containing perforated pipes and porous material (often gravel) covered by a layer of soil to prevent animals (and surface runoff) from reaching the wastewater distributed within those trenches. [1]
Unlike the traditional septic system, the aerobic treatment system produces a high quality secondary effluent, which can be sterilized and used for surface irrigation. This allows much greater flexibility in the placement of the leach field, as well as cutting the required size of the leach field by as much as half. [1]
A percolation test (colloquially called a perc test) is a test to determine the water absorption rate of soil (that is, its capacity for percolation) in preparation for the building of a septic drain field (leach field) or infiltration basin. [1] The results of a percolation test are required to design a septic system properly.
Mound systems are an alternative to the traditional rural septic system drain field. They are used in areas where septic systems are prone to failure from extremely permeable or impermeable soils, soil with the shallow cover over porous bedrock, and terrain that features a high water table.
The vent pipe should have an internal diameter of at least 110 mm (4¼") and reach more than 300 mm (12") above the highest point of the toilet superstructure. Typically, the pit is at least 3 metres (10') deep and 1 to 1.5 metres (3' to 5') in diameter, depending on the number of users. Deep pits can last up to 20 or more years. [30]
Effluent pumping sewers have small diameter pipes that follow the contour of the land and are only buried a metre or two underground. While an effluent sewer can use gravity to move waste, the ability to move waste with a pressure system can be a big advantage in places where a gravity system is impractical.
This was very labour-intensive but could often be done using free materials at hand. Typically they were two to three feet (600mm-900mm) below the surface. Agricultural land drains have to be installed sufficiently deep to avoid plough damage. In 1843 in England short earthenware pipes were first used laid edge to edge. The earliest type ...
Orangeburg pipe was made of wood pulp sealed with liquified coal tar pitch in inside diameters from 2 inches to 18 inches, with a perforated version for leach fields. . Joints were made of the same material, and, because of the residual stickiness of the coal tar, were sealed without adh