enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Affinity laws - Wikipedia

   en.wikipedia.org/wiki/Affinity_laws

   The affinity laws are useful as they allow the prediction of the head discharge characteristic of a pump or fan from a known characteristic measured at a different speed or impeller diameter. The only requirement is that the two pumps or fans are dynamically similar, that is, the ratios of the fluid forced are the same.

3. Air changes per hour - Wikipedia

   en.wikipedia.org/wiki/Air_changes_per_hour

   Q = Volumetric flow rate of air in cubic feet per minute (cfm) Vol = Space volume L × W × H, in cubic feet; In metric units = where: ACPH = number of air changes per hour; higher values correspond to more ventilation; Q = Volumetric flow rate of air in liters per second (L/s)

4. Specific fan power - Wikipedia

   en.wikipedia.org/wiki/Specific_fan_power

   In reality the fan system efficiency is often in the range 0 to 60% (i.e. <); it is lowest for small fans or inefficient operating points (e.g. throttled flow or free-flow). The efficiency is a function of the total losses in the fan system, including aerodynamic losses in the fan, friction losses in the drive (e.g. belt), losses in the ...

5. How Much Does It Cost to Replace a Water Heater? - AOL

   www.aol.com/lifestyle/much-does-cost-replace...

   Gas water heaters cost between $600 and $2,700 to replace, for an average cost of about $1,650. ... Power-vent heaters are more expensive and use a fan or blower, plus electricity.

6. Actual cubic feet per minute - Wikipedia

   en.wikipedia.org/wiki/Actual_cubic_feet_per_minute

   Actual cubic feet per minute (ACFM) is a unit of volumetric flow. It is commonly used by manufacturers of blowers and compressors. [1] This is the actual gas delivery with reference to inlet conditions, whereas cubic foot per minute (CFM) is an unqualified term and should only be used in general and never accepted as a specific definition without explanation.

7. Blower door - Wikipedia

   en.wikipedia.org/wiki/Blower_door

   Fan airflow is determined using C Fan and n Fan values that are provided by the blower door manufacturer, and they are used to calculate Q Fan. The multi-point blower door test procedure results in a series of known values of Q n, Fan and ∆P n, Building. Typical ∆P n, Building values are ±5, 10, 20, 30, 40 and 50 pascal.

8. Centrifugal fan - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_fan

   A centrifugal fan is a mechanical device for moving air or other gases in a direction at an angle to the incoming fluid. Centrifugal fans often contain a ducted housing to direct outgoing air in a specific direction or across a heat sink; such a fan is also called a blower, blower fan, or squirrel-cage fan (because it looks like a hamster wheel).

9. Standard cubic feet per minute - Wikipedia

   en.wikipedia.org/wiki/Standard_cubic_feet_per_minute

   To further confuse the issue, a centrifugal fan is a constant CFM device or a constant volume device. This means that, provided the fan speed remains constant, a centrifugal fan will pump a constant volume of air. This is not the same as pumping a constant mass of air. Again, the fan will pump the same volume, though not mass, at any other air ...