enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Shiplap - Wikipedia

   en.wikipedia.org/wiki/Shiplap

   Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm (3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm (3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [1] The rabbet allows the boards to overlap in this area.

3. Wood Paneling Is Back—and Better Than Ever - AOL

   www.aol.com/lifestyle/wood-paneling-back-better...

   Raised panel wood paneling is used to create a grid effect on a wall or the lower third of a wall. The individual panels have framed insets with beveled edges. Kitchen cabinets commonly use this ...

4. Panelling - Wikipedia

   en.wikipedia.org/wiki/Panelling

   Wood wall panelling has seen a resurgence in popularity in recent years due to its aesthetic appeal, versatility, and sustainability. Traditionally used to insulate and decorate interiors, modern wood panelling includes wainscoting, beadboard, shiplap, board and batten, and both raised and flat panels. This renewed interest is driven by the ...

5. Plywood - Wikipedia

   en.wikipedia.org/wiki/Plywood

   The ancient Egyptians and Greeks cut wood thinly and glued it together in layers with the grain in perpendicular directions as fine wood was in short supply. This is believed to have been done purely for cosmetic and economical purposes but it turned out to be a great alternative to pure wood as it reduced flex, making it a versatile building material.

6. Medium-density fibreboard - Wikipedia

   en.wikipedia.org/wiki/Medium-density_fibreboard

   The density of the board, when evaluated in relation to the density of the fibre that goes into making the panel, is important. A thick MDF panel at a density of 700–720 kg/m 3 (44–45 lb/cu ft) may be considered as high density in the case of softwood fibre panels, whereas a panel of the same density made of hardwood fibres is not regarded ...

7. Oriented strand board - Wikipedia

   en.wikipedia.org/wiki/Oriented_strand_board

   The number of layers placed is determined partly by the thickness of the panel, but is limited by the equipment installed at the manufacturing site. Individual layers can also vary in thickness to give different finished panel thicknesses; typically, a 15 cm (5.9 in) layer will produce a 15 mm (0.59 in) panel thickness [citation needed]. The ...