enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

3. Check valve - Wikipedia

   en.wikipedia.org/wiki/Check_valve

   A check valve, non-return valve, reflux valve, retention valve, foot valve, or one-way valve is a valve that normally allows fluid (liquid or gas) to flow through it in only one direction. [1] Check valves are two-port valves, meaning they have two openings in the body, one for fluid to enter and the other for fluid to leave. There are various ...

4. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.

5. Well drainage - Wikipedia

   en.wikipedia.org/wiki/Well_drainage

   Map of a well field for subsurface drainage with radial flow across concentrical cylinders representing the equipotentials. Both systems serve the same purposes, namely water table control and soil salinity control. Both systems can facilitate the reuse of drainage water (e.g. for irrigation), but wells offer more flexibility.

6. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Turning a valve knob or lever adjusts flow by varying the aperture of the control device in the valve assembly. The result when opened in any degree is a choked flow . Its rate is independent of the viscosity or temperature of the fluid or gas in the pipe, and depends only weakly on the supply pressure , so that flow rate is stable at a given ...

7. Downhole safety valve - Wikipedia

   en.wikipedia.org/wiki/Downhole_safety_valve

   This means that they are installed as a component of the completion string and run in during completion. Retrieving the valve, should it malfunction, requires a workover. The full name for this most common type of downhole safety valve is a Tubing Retrievable Surface Controlled Sub-Surface Valve, shortened in completion diagrams to TRSCSSV.

8. Blowout preventer - Wikipedia

   en.wikipedia.org/wiki/Blowout_preventer

   A blowout preventer (BOP) (pronounced B-O-P) [1] is a specialized valve or similar mechanical device, used to seal, control and monitor oil and gas wells to prevent blowouts, the uncontrolled release of crude oil or natural gas from a well. They are usually installed in stacks of other valves.

9. Dry well - Wikipedia

   en.wikipedia.org/wiki/Dry_well

   A dry well or drywell is an underground structure that disposes of unwanted water, most commonly surface runoff and stormwater, in some cases greywater or water used in a groundwater heat pump. It is a gravity-fed , vertical underground system that can capture surface water from impervious surfaces , then store and gradually infiltrate the ...