Ads
related to: parts of floppy drive cable and connectors
Search results
Results from the WOW.Com Content Network
Most controllers support two floppy drives, so a cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a combination. After IBM introduced the "twist" to floppy cables, and when both 5.25-inch and 3.5-inch drives were in common use, many cables had four connectors: one of each type before the twist, and one of each type ...
Rear side of 3.5-inch floppy drive. Berg connector for power is shown on the left; data cable on right. Berg connector is a brand of electrical connector used in computer hardware. Berg connectors are manufactured by Berg Electronics Corporation of St. Louis, Missouri, now part of Amphenol.
The first 5.25-inch floppy disk drive, the Shugart SA400, introduced in August 1976, used the AMP Mate-n-Lok connector part number 350211-1. [4] This connector became the standard for 5.25-inch format peripherals such as hard drives and was used until introduction of SATA drives.
A ribbon cable is a cable with many conducting wires running parallel to each other on the same flat plane. As a result, the cable is wide and flat. Its name comes from its resemblance to a piece of ribbon. [1] Ribbon cables are usually seen for internal peripherals in computers, such as hard drives, CD drives and floppy drives.
Starting with the 80-conductor cable defined for use in ATAPI5/UDMA4, the master Device 0 device goes at the far-from-the-host end of the 18-inch (460 mm) cable on the black connector, the slave Device 1 goes on the grey middle connector, and the blue connector goes to the host (e.g. motherboard IDE connector, or IDE card).
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
IEC 60320, connectors for power supply cords to electrical appliances; Molex connector, four-pin hard disk drive (HDD) connectors, also used for powering CD-ROM drives, burners etc. Berg connector, smaller four pin floppy disk drive (FDD) connectors, also used by some hard drives, and carrying the same power supplies as the HDD connectors
Ads
related to: parts of floppy drive cable and connectors