Search results
Results from the WOW.Com Content Network
These cables still only supported two drives, one before and one after the twist, but they allowed using one cable for any combination of drives with differing connectors. This type of cable is called a universal cable. [8] When multiple floppy disks are connected, many pins are shared, including the read and write data pins.
English: Diagram illustrating the basic internal parts of a 3.5" floppy disk. Document labels rendered as numbers to aid in internationalization. Note: The unlabeled square in the upper left is the approximate location of the write protection tab.
Example part numbers are any of TE Connectivity / AMP 170204-* (loose pieces) or 170262-* (pieces supplied in strips), where * is 1 or 2 or 4. [2] [3] The male PCB connector on the 3½-inch floppy drive is normally a polarized right-angle male header, which is a TE Connectivity / AMP 171826-4, [4] the straight model is AMP 171825-4. [5]
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm). These types are used for many types of equipment, in particular for interconnections within an enclosure. For personal computers, this size was used in floppy-disk-drive cables and older or custom Parallel ATA cables.
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.