enow.com Web Search

  1. Ads

    related to: fixed coaxial attenuator antenna

Search results

  1. Results from the WOW.Com Content Network
  2. Attenuator (electronics) - Wikipedia

    en.wikipedia.org/wiki/Attenuator_(electronics)

    Fixed attenuators in circuits are used to lower voltage, dissipate power, and to improve impedance matching. In measuring signals, attenuator pads or adapters are used to lower the amplitude of the signal a known amount to enable measurements, or to protect the measuring device from signal levels that might damage it. Attenuators are also used ...

  3. Coaxial antenna - Wikipedia

    en.wikipedia.org/wiki/Coaxial_antenna

    A coaxial antenna (often known as a coaxial dipole) is a particular form of a half-wave dipole antenna, most often employed as a vertically polarized omnidirectional antenna. History [ edit ]

  4. Optical attenuator - Wikipedia

    en.wikipedia.org/wiki/Optical_attenuator

    An optical attenuator, or fiber optic attenuator, is a device used to reduce the power level of an optical signal, either in free space or in an optical fiber. The basic types of optical attenuators are fixed, step-wise variable, and continuously variable.

  5. Antenna types - Wikipedia

    en.wikipedia.org/wiki/Antenna_types

    The category of simple antennas consists of dipoles, monopoles, and loop antennas. Nearly all can be made with a single segment of wire (ignoring the break made in the wire for the feedline connection). [citation needed] Dipoles and monopoles called linear antennas (or straight wire antennas) since their radiating parts lie along a single ...

  6. Attenuation - Wikipedia

    en.wikipedia.org/wiki/Attenuation

    There also exist optical attenuators that decrease the signal in a fiber optic cable intentionally. Attenuation of light is also important in physical oceanography . This same effect is an important consideration in weather radar , as raindrops absorb a part of the emitted beam that is more or less significant, depending on the wavelength used.

  7. AN/FRD-10 - Wikipedia

    en.wikipedia.org/wiki/AN/FRD-10

    The system had 120 high band antennas and 40 low band antennas which had to be positioned within +/- two minutes of arc and +/- 3 inches of their intended distance from the center of the array. 160 75 ohm coaxial transmission lines were used to carry signals from the antennas had to be electrically matched to within 3/4 of a degree at 10 MHz.

  1. Ads

    related to: fixed coaxial attenuator antenna