enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   A self-drilling screw and three thread-cutting screws. Some self-tapping screws such as the Tek screw brand, are also self-drilling, which means that in addition to the thread-forming section there is also a fluted tip much like the tip of a center drill.

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   self-tapping machine screw: A self-tapping machine screw is similar to a machine screw, except the lower part of the shank is designed to cut threads as the screw is driven into an untapped hole. The advantage of this screw type over a self-drilling screw is that, if the screw is reinstalled, new threads are not cut as the screw is driven. set bolt

4. Pentalobular screw thread - Wikipedia

   en.wikipedia.org/wiki/Pentalobular_screw_thread

   A pentalobular screw thread is a form of self-forming thread used for screws. Self-forming screws are used in ductile materials, such as aluminium and plastics. Self-tapping screws are widely used for driving into sheet metal or plastics and forming their own thread. They may be either self-drilling, forming their own hole through unbroken ...

5. Pilot hole - Wikipedia

   en.wikipedia.org/wiki/Pilot_hole

   By drilling a small pilot hole into the material, into which a screw is then driven, less wedging takes place, thereby reducing the likelihood of the material being split. [2] When a screw is driven without a pilot hole, or with too small a pilot hole, the core of the screw may bind and lead to the screw being broken.

6. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit. These screws are often blue, white, or stainless ...

7. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...