enow.com Web Search

  1. Ads

    related to: overhead door safety sensor troubleshooting

Search results

  1. Results from the WOW.Com Content Network
  2. Electric eye - Wikipedia

    en.wikipedia.org/wiki/Electric_eye

    Electric eye for a garage door opener. An electric eye is a photodetector used for detecting obstruction of a light beam. An example is the door safety system used on garage door openers that use a light transmitter and receiver at the bottom of the door to prevent closing if there is any obstruction in the way that breaks the light beam.

  3. Garage door opener - Wikipedia

    en.wikipedia.org/wiki/Garage_door_opener

    The electric overhead garage door opener was invented by C.G. Johnson in 1926 in Hartford City, Indiana. [1] Electric Garage Door openers did not become popular until Era Meter Company of Chicago offered one after World War II where the overhead garage door could be opened via a key pad located on a post at the end of the driveway or a switch inside the garage.

  4. Garage door - Wikipedia

    en.wikipedia.org/wiki/Garage_door

    Sectional garage door Up-and-over garage door Garage Door Hardware. A garage door is a large door to allow egress for a garage that opens either manually or by an electric motor (a garage door opener). Garage doors are frequently large enough to accommodate automobiles and other vehicles. The operating mechanism is usually spring-loaded or ...

  5. Output signal switching device - Wikipedia

    en.wikipedia.org/wiki/Output_Signal_Switching_Device

    An output signal switching device (OSSD) is an electronic device used as part of the safety system of a machine. It provides a coded signal which, when interrupted due to a safety event, signals the machine to shut down. It works by converting the standard direct current supply, usually 24 volts, into two pulsed and out-of-phase signals.

  6. 50 Times Cheap Fixes Had A Major Impact On Home Life - AOL

    www.aol.com/55-people-share-relatively-cheap...

    D codes to fix both problems by cutting a set of stairs into the middle of the wall. Only had to cut 2 of the old big blocks in half as the pavers fit perfectly with the spacing of the blocks.

  7. Swing-door operator - Wikipedia

    en.wikipedia.org/wiki/Swing-door_operator

    A door operator may use sensors to prevent the door from coming into contact with a user. Full Energy operators require at least 3 sensors. Low-energy operators are not required to have safety sensors, as the door is allowed to come in contact with a user, given that the kinetic energy of the moving door is limited by the reduced moving speed.

  1. Ads

    related to: overhead door safety sensor troubleshooting