Search results
Results from the WOW.Com Content Network
In carburetted engines the lever is called throttle lever and controls the mass flow rate of the air-fuel mixture delivered to the cylinders by the amount of throttle valve opening. In engines with fuel injection system, the lever is typically referred to as power lever and controls the amount of fuel that is injected into the cylinders.
A throttle body is somewhat analogous to the carburetor in a non-injected engine, although it is important to remember that a throttle body is not the same thing as a throttle, and that carbureted engines have throttles as well. A throttle body simply supplies a convenient place to mount a throttle in the absence of a carburetor venturi.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
When the throttle is opened (in a car, the accelerator pedal is depressed), ambient air is free to fill the intake manifold, increasing the pressure (filling the vacuum). A carburetor or fuel injection system adds fuel to the airflow in the correct proportion, providing energy to the engine. When the throttle is opened all the way, the engine's ...
Under part throttle conditions (i.e. when the throttle is less than fully open), the effective compression ratio is less than when the engine is operating at full throttle, due to the simple fact that the incoming fuel-air mixture is being restricted and cannot fill the chamber to full atmospheric pressure. The engine efficiency is less than ...
Thrust levers in a Boeing 747 Classic. The center and rear levers are used during flight, while the forward levers control reverse thrust.. Thrust levers or throttle levers are found in the cockpit of aircraft, and are used by the pilot, copilot, flight engineer, or autopilot to control the thrust output of the aircraft's engines, by controlling the fuel flow to those engines. [1]
The system operates through controlling the flow of hydraulic engine oil pressure to locking mechanisms in the cam followers. The engine's drive by wire throttle allows the engine management computer to smooth out the engine's power delivery, making the system nearly imperceptible on some vehicles. When the VCM system disables cylinders, an ...
In this article, the terms multi-point injection (MPI), and single-point injection (SPI) are used. In an MPI system, there is one fuel injector per cylinder, installed very close to the intake valve(s). In an SPI system, there is only a single fuel injector, usually installed right behind the throttle valve.