Ad
related to: throttle vs throttling and separating oil and fuel cylinder headsebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Fuel primer pump - A manual pump to add a small amount of fuel at the cylinder intakes to assist in starting a cold engine. Fuel-injected engines do not have this control. For fuel-injected engines, a fuel boost pump is used to prime the engine prior to start. Fuel quantity gauge - Indicates the amount of fuel remaining in the identified tank ...
A throttle body is somewhat analogous to the carburetor in a non-injected engine, although it is important to remember that a throttle body is not the same thing as a throttle, and that carbureted engines have throttles as well. A throttle body simply supplies a convenient place to mount a throttle in the absence of a carburetor venturi.
The butterfly valve often contains a small "idle cutout", a hole that allows small amounts of fuel/air mixture into the engine even when the valve is fully closed, or the carburetor has a separate air bypass with its own idle jet. If the engine is operating under light or no load and low or closed throttle, there is high manifold vacuum.
Thus the mixture of fuel and air in the cylinder could not be controlled via the crankcase intake. The "throttle" (fuel valve) of a monosoupape provided only a limited degree of speed regulation, as opening it made the mixture too rich, while closing it made it too lean (in either case quickly stalling the engine, or damaging the cylinders).
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
Amount of two-stroke oil injected by the pump depends on the throttle position. A cable from the throttle is connected to the oil pump indicating throttle's position. A tube ensures flow of oil from the reservoir to the oil pump. This system is commonly used for motorcycles as it eliminates the need of pre-mixing fuel and two-stroke oil. Vespa ...
Intake air throttling changes the amount of air sucked into the engine, which means that if a stoichiometric air-fuel mixture is desired, the amount of injected fuel has to be changed along with the intake air throttling. To do so, manifold injection systems have at least one way to measure the amount of air that is currently being sucked into ...
Thrust levers in a Boeing 747 Classic. The center and rear levers are used during flight, while the forward levers control reverse thrust.. Thrust levers or throttle levers are found in the cockpit of aircraft, and are used by the pilot, copilot, flight engineer, or autopilot to control the thrust output of the aircraft's engines, by controlling the fuel flow to those engines. [1]
Ad
related to: throttle vs throttling and separating oil and fuel cylinder headsebay.com has been visited by 1M+ users in the past month