enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB communications - Wikipedia

   en.wikipedia.org/wiki/USB_communications

   High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0. High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts. Connectors are identical for USB 2.0 and USB 1.x. SuperSpeed (SS) rate of 5.0 Gbit/s. The written USB 3.0 specification was ...

3. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   The USB-IF used WiGig Serial Extension v1.2 specification as its initial foundation for the MA-USB specification and is compliant with SuperSpeed USB (3.0 and 3.1) and Hi-Speed USB (USB 2.0). Devices that use MA-USB will be branded as "Powered by MA-USB", provided the product qualifies its certification program. [110]

4. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...

5. USB Attached SCSI - Wikipedia

   en.wikipedia.org/wiki/USB_Attached_SCSI

   USB 3.0 SuperSpeed and USB 2.0 High-Speed versions defined USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions

6. USB On-The-Go - Wikipedia

   en.wikipedia.org/wiki/USB_On-The-Go

   USB OTG defines two roles for devices: OTG A-device and OTG B-device, specifying which side supplies power to the link, and which initially is the host. The OTG A-device is a power supplier, and an OTG B-device is a power consumer. In the default link configuration, the A-device acts as a USB host with the B-device acting as a USB peripheral ...

7. Extensible Host Controller Interface - Wikipedia

   en.wikipedia.org/wiki/Extensible_Host_Controller...

   The xHCI reduces the need for periodic device polling by allowing a USB 3.0 or later device to notify the host controller when it has data available to read, and moves the management of polling USB 2.0 and 1.1 devices that use interrupt transactions from the CPU-driven USB driver to the USB host controller.