enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Key (engineering) - Wikipedia

    en.wikipedia.org/wiki/Key_(engineering)

    Square keys are used for smaller shafts and rectangular faced keys are used for shaft diameters over 6.5 in (170 mm) or when the wall thickness of the mating hub is an issue. Set screws often accompany parallel keys to lock the mating parts into place. [3] The keyway is a longitudinal slot in both the shaft and mating part.

  3. Engineering drawing abbreviations and symbols - Wikipedia

    en.wikipedia.org/wiki/Engineering_drawing...

    CAD: computer-aided design, computer-aided drafting; cadmium [plating]: CAGE: Commercial and Government Entity [code]: A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing.

  4. Hex key - Wikipedia

    en.wikipedia.org/wiki/Hex_key

    The idea of a hex socket screw drive was probably conceived as early as the 1860s to the 1890s, but such screws were probably not manufactured until around 1910. Rybczynski (2000) describes a flurry of patents for alternative drive types in the 1860s to the 1890s in the U.S., [2] which are confirmed to include internal-wrenching square and triangle types (that is, square and triangular sockets ...

  5. List of DIN standards - Wikipedia

    en.wikipedia.org/wiki/List_of_DIN_standards

    This is an incomplete list of DIN standards.. The "STATUS" column gives the latest known status of the standard.. If a standard has been withdrawn and no replacement specification is listed, either the specification was withdrawn without replacement or a replacement specification could not be identified.

  6. Shaft (mechanical engineering) - Wikipedia

    en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

    The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.

  7. Broaching (metalworking) - Wikipedia

    en.wikipedia.org/wiki/Broaching_(metalworking)

    Also, there are limits on the size of internal cuts. Common internal holes can range from 0.125 to 6 in (3.2 to 152.4 mm) in diameter but it is possible to achieve a range of 0.05 to 13 in (1.3 to 330.2 mm). Surface broaches' range is usually 0.075 to 10 in (1.9 to 254.0 mm), although the feasible range is 0.02 to 20 in (0.51 to 508.00 mm).

  8. Is there already a College Football Playoff controversy ...

    www.aol.com/sports/college-football-playoff...

    The College Football Playoff selection committee enters its final two weeks of deliberation with a host of consequential decisions thrust on the 13 members.

  9. Keyway - Wikipedia

    en.wikipedia.org/wiki/Keyway

    Keyway may refer to: A part of a keyed joint used to connect a rotating machine element to a shaft; see key (engineering) A keyhole , a hole or aperture (as in a door or lock) for receiving a key; see lock and key