Search results
Results from the WOW.Com Content Network
The centimetre (SI symbol: cm) is a unit of length in the metric system equal to 10 −2 metres ( 1 / 100 m = 0.01 m). To help compare different orders of magnitude, this section lists lengths between 10 −2 m and 10 −1 m (1 cm and 1 dm). 1 cm – 10 millimeters; 1 cm – 0.39 inches; 1 cm – edge of a square of area 1 cm 2
The table below lists units supported by ... (6.5 cm 2) sqin cm2; Other: ... 231 cubic inches by definition, also
The kayser (K) is a unit of wavenumber equal to 1 cm −1 (100 m −1). The gal (Gal) is a unit of acceleration equal to 1 cm/s 2. [3] The dyne (dyn) is a unit of force equal to 1 g⋅cm⋅s −2 (10 μN). [3] The barye (Ba) is a unit of pressure equal to 1 dyn⋅cm −2 (100 mPa). The erg (erg) is a unit of energy equal to 1 dyn⋅cm (100 nJ). [3]
2.817 940 285 (31) × 10 −15 [13] The Compton wavelength of the electron λ C: 2.426 310 215 (18) × 10 −12 [13] The reduced Compton wavelength of the electron λ C: 3.861 592 6764 (18) × 10 −13 [14] The Compton wavelength (or reduced Compton wavelength) of any fundamental particle λ x: The Bohr radius of the hydrogen atom (Atomic unit ...
Chart illustrating the increase in height of racehorses, from 14 hh (142 cm) in 1700 to 15. 2 + 1 ⁄ 2 hh (159 cm) in 1900. Today the hand is used to measure the height of horses, [2] ponies, and other equines. It is used in the US and also in some other nations that use the metric system, such as Australia, New Zealand, Canada, Ireland and ...
The United States retained the 1 / 39.37 -metre definition for surveying, producing a 2 millionth part difference between standard and US survey inches. [47] This is approximately 1 / 8 inch per mile; 12.7 kilometres is exactly 500,000 standard inches and exactly 499,999 survey inches.
Grows to 2.5m tall, leaves are green, glaucous and relatively narrow (4–13 cm/1½-5 inches wide). The flowers are erect, yellow, relatively small (3–4 cm/1¼-1½inches long), composed of 9 coloured parts; sepals obtuse; petals reflexed; 4 staminodes, narrow (2-10mm/¼-½inch wide).
[2] [3] [4] The factor–label method is the sequential application of conversion factors expressed as fractions and arranged so that any dimensional unit appearing in both the numerator and denominator of any of the fractions can be cancelled out until only the desired set of dimensional units is obtained.