Search results
Results from the WOW.Com Content Network
Because of the limitations of well clusters and nested wells and a desire for monitoring more vertical intervals, researchers at the University of Waterloo (Canada) developed a MLS to collect depth-discrete groundwater samples at a landfill site in Ontario, Canada (Pickens et al. 1978). That system, which contained multiple tubes within an ...
a bailer used for sampling groundwater. A bailer in hydrogeology is a hollow tube used to retrieve groundwater samples from monitoring wells. The wells are typically built out of PVC casing which is slotted to allow groundwater to flow freely through the well.
Nested wells, also referred to as nested monitoring wells, are composed of multiple tubes or pipes, typically terminating with short screened intervals (2–3 ft), installed in single boreholes. Sand packs must be installed at the screen depths and seals in the borehole are constructed between the sand packs.
A tube well is a type of water well in which a long, 100–200 millimetres (3.9–7.9 in)-wide, stainless steel tube or pipe is bored underground. The lower end is fitted with a strainer, and a pump lifts water for irrigation. The required depth of the well depends on the depth of the water table.
An example of a non-discretized radial model is the description of groundwater flow moving radially towards a deep well in a network of wells from which water is abstracted. [7] The radial flow passes through a vertical, cylindrical, cross-section representing the hydraulic equipotential of which the surface diminishes in the direction of the ...
Often the well efficiency is determined from this sort of test, this is a percentage indicating the fraction of total observed drawdown in a pumping well which is due to aquifer losses (as opposed to being due to flow through the well screen and inside the borehole). A perfectly efficient well, with perfect well screen and where the water flows ...
In hydrogeology, an aquifer test (or a pumping test) is conducted to evaluate an aquifer by "stimulating" the aquifer through constant pumping, and observing the aquifer's "response" in observation wells. Aquifer testing is a common tool that hydrogeologists use to characterize a system of aquifers, aquitards and flow system boundaries.
Because the flow rate into or out of the well is not constant, as is the case in a typical aquifer test, the standard Theis solution does not work. Mathematically , the Theis equation is the solution of the groundwater flow equation for a step increase in discharge rate at the pumping well; a slug test is instead an instantaneous pulse at the ...