Search results
Results from the WOW.Com Content Network
The name, derived from an old English practice of bore measurements in gun-making which refers to a nominally 4-gauge bore, that is, a bore diameter that would accommodate a pure lead round ball weighing 1 ⁄ 4 of a pound. This would imply a bore diameter of 1.052-inch (26.7 mm), however in practice the bore diameter varied greatly as, in ...
In 1914 and 1915, the Forestry Quarterly published a series of articles on the use of the Abney level. [6] [7] [8] These tutorial articles remain useful today, but the primary reference for usage is the 1927 Abney Level Handbook. [3] The Abney level is typically used at the eye height of the surveyor, either hand-held or mounted on a staff at ...
This will be the accurate measurement in reference to the nominal value that the dial bore gauge was zeroed at. For example, if the gauge was set for a nominal value of 4.000 inches, and the gauge measures 0.002 inches, the size of the bore is 4.002 inches. [citation needed]
The Y level or wye level is the oldest and bulkiest of the older style optical instruments. A low-powered telescope is placed in a pair of clamp mounts, and the instrument then leveled using a spirit level, which is mounted parallel to the main telescope. The term dumpy level (also builder's level) endures despite the evolution in design. They ...
4/3's published facts: "Size of the 4/3-type Sensor: The standard diagonal length of the sensor is 21.63 millimetres (0.852 in). It is half that of 35-mm film format (36 millimetres (1.4 in) x 24 millimetres (0.94 in) = 43.27 millimetres (1.704 in)) The image circle of the interchangeable lens is specified based on this diagonal length. The ...
An example could be to mount a scope with a 1-inch (25.4 mm) tube in a 30 mm mount using a plastic insert. There are also special ring mounts in the market with circularly shaped ring inserts made to provide stress free mounting without lapping, with Burris Signature Rings and Sako Optilock Rings as two well-known examples.
Note: Use of this table for estimating bullet masses for historical large-bore rifles is limited, as this table assumes the use of round ball, rather than conical bullets; for example, a typical 4-bore rifle from circa 1880 used a 2,000-grain (4.57 oz; 129.60 g) bullet, or sometimes slightly heavier, rather than using a 4-ounce (110 g) round ...
The M39 lens mount is a screw thread mounting system for attaching lenses to 35 mm cameras, primarily rangefinder (RF) Leicas. It is also the most common mount for Photographic enlarger lenses. True Leica Thread-Mount (LTM) is 39 mm in diameter and has a thread of 26 turns-per-inch or threads-per-inch (tpi) (approximately 0.977 mm pitch) of ...