Search results
Results from the WOW.Com Content Network
The purpose of the circuit is to start the TRIAC conducting very near the time point when the load voltage is crossing zero (at the beginning or the middle of each AC cycle represented by a sine wave), so that the output voltage begins as a complete sine-wave half-cycle.
A TRIAC (triode for alternating current; also bidirectional triode thyristor or bilateral triode thyristor [1]) is a three-terminal electronic component that conducts current in either direction when triggered. The term TRIAC is a genericised trademark.
A zero-crossing is a point where the sign of a mathematical function changes (e.g. from positive to negative), represented by an intercept of the axis (zero value) in the graph of the function. It is a commonly used term in electronics, mathematics, acoustics, and image processing.
A QUADRAC is a special type of thyristor which combines a DIAC and a TRIAC in a single package. The DIAC is the triggering device for the TRIAC. Thyristors are four-layer (PNPN) semiconductor devices that act as switches, rectifiers or voltage regulators in a variety of applications. When triggered, thyristors turn on and become low-resistance ...
An example of PWM [clarification needed] in an idealized inductor driven by a voltage source modulated as a series of pulses, resulting in a sine-like current in the inductor. The rectangular voltage pulses nonetheless result in a more and more smooth current waveform, as the switching frequency increases. The current waveform is the integral ...
In the following example crowbar circuit, the LM431 adjustable zener regulator controls the gate of the TRIAC. The resistor divider of R 1 and R 2 provide the reference voltage for the LM431. The divider is set so that during normal operating conditions, the voltage across R 2 is slightly lower than V REF of the LM431. Since this voltage is ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
Solid state relay with green LED Solid state contactor PCB mount solid-state DIL relay. A solid state relay (SSR) is an electronic switching device that switches on or off when an external voltage (AC or DC) is applied across its control terminals.