Search results
Results from the WOW.Com Content Network
The 'log pot', that is, a potentiometer has a resistance, taper, or, "curve" (or law) of a logarithmic (log) form, is used as the volume control in audio power amplifiers, where it is also called an "audio taper pot", because the amplitude response of the human ear is approximately logarithmic. It ensures that on a volume control marked 0 to 10 ...
The taper is variously referred to as NMTB, NMT or NT. The taper is 3.500 inches per foot and is also referred to as "7 in 24" or 7/24; the computed angle is 16.5943 degrees. [8] All NMTB tooling has this taper but the tooling comes in different sizes: NMTB-10, 15, 20, 25, 30, 35, 40, 45, 50 and 60.
Example of true position geometric control defined by basic dimensions and datum features. Geometric dimensioning and tolerancing (GD&T) is a system for defining and communicating engineering tolerances via a symbolic language on engineering drawings and computer-generated 3D models that describes a physical object's nominal geometry and the permissible variation thereof.
A cylinder with longitudinal draft Profile view of a drafted cylinder with the draft dimension. In engineering, draft is the amount of taper for molded or cast parts perpendicular to the parting line. It can be measured in degrees or mm/mm (in/in). Consider the fabrication of a hollow plastic box, without lid.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
When a dimension is defined in one view but also mentioned again in another view, it will be given as reference in the second case. This rule prevents the mistake of defining it in two different ways accidentally; the "main" (non-reference) mention is the only one that counts as a feature definition and thus as a part acceptance criterion.
The affinity laws are useful as they allow the prediction of the head discharge characteristic of a pump or fan from a known characteristic measured at a different speed or impeller diameter. The only requirement is that the two pumps or fans are dynamically similar, that is, the ratios of the fluid forced are the same.
A fan controller with LEDs indicating fan status and potentiometers and switches to control fan speeds. Another method, popular with PC hardware enthusiasts, is the manual fan speed controller. They can be mounted in an expansion slot or a 5.25" or 3.5" drive bay or come built into a computer's case. Using switches or knobs, attached fans can ...