Ad
related to: hatsan striker trigger for sale by owner
Search results
Results from the WOW.Com Content Network
Firearms use triggers to initiate the firing of a cartridge seated within the gun barrel chamber.This is accomplished by actuating a striking device through a combination of mainspring (which stores elastic energy), a trap mechanism that can hold the spring under tension, an intermediate mechanism to transmit the kinetic energy from the spring releasing, and a firing pin to eventually strike ...
A binary trigger (or pull and release trigger) is a type of device that allows a semi-automatic firearm to fire at an increased rate. A binary trigger works by firing one shot upon pulling the trigger and then firing a subsequent shot upon release of the trigger. Binary triggers are installed through modification of the fire-control group.
A forced reset trigger (or "hard reset" trigger) is a device that allows a person to fire a semi-automatic firearm at an increased rate. The forced reset trigger works by mechanically resetting the trigger's position after a shot is fired. This allows for an increased rate of fire.
Sear shown in a revolver action Sear (B), in a rifle. In a firearm, the sear is the part of the trigger mechanism that holds the hammer, striker, or bolt back until the correct amount of pressure has been applied to the trigger, at which point the hammer, striker, or bolt is released to discharge the weapon.
The VP9 trigger has a short, light take-up with a solid, single action type break followed by a short positive reset. The average weight of the stock trigger pull is 5.2 lb f (23 N). The VP9 trigger has a consistent pre-travel pull followed by a positive set with clean break. Disassembly does not involve releasing the striker by squeezing the ...
The Savage Striker was a bolt action pistol produced from 1999 to 2005 by Savage Arms for metallic silhouette shooting and hunting.The pistol was based on the action of the Savage Model 110 and was sold with a composite stock, originally with a center grip, but later also with a rear grip as an alternative.
A typical striker consists of a narrow striking point, a heavier section that acts as a spring guide for the striker spring, a shoulder to restrain the spring, and a catch piece which is engaged by the trigger sear to hold the spring under tension when "cocked" and ready to fire. The striker spring is compressed between the striker's shoulder ...
An auto sear ("automatic sear") is a part of an automatic firearm that holds the hammer in the cocked position while the bolt of the weapon is cycling and releases the hammer/striker. It is basically an internal trigger actuated by the bolt/bolt carrier when placed in-battery. An auto sear is required in nearly every automatic rifle.
Ad
related to: hatsan striker trigger for sale by owner