Search results
Results from the WOW.Com Content Network
The centipoise is convenient because the viscosity of water at 20 °C is about 1 cP, and one centipoise is equal to the SI millipascal second (mPa·s). The SI unit of kinematic viscosity is square meter per second (m 2 /s), whereas the CGS unit for kinematic viscosity is the stokes (St, or cm 2 ·s −1 = 0.0001 m 2 ·s −1), named after Sir ...
For kinematic viscosity, the SI unit is m^2/s. In engineering, the unit is usually Stoke or centiStoke, with 1 Stoke = 0.0001 m^2/s, and 1 centiStoke = 0.01 Stoke. For liquid, the dynamic viscosity is usually in the range of 0.001 to 1 Pascal-second, or 1 to 1000 centiPoise. The density is usually on the order of 1000 kg/m^3, i.e. that of water.
The poise is often used with the metric prefix centi-because the viscosity of water at 20 °C (standard conditions for temperature and pressure) is almost exactly 1 centipoise. [3] A centipoise is one hundredth of a poise, or one millipascal-second (mPa⋅s) in SI units (1 cP = 10 −3 Pa⋅s = 1 mPa⋅s). [4] The CGS symbol for the centipoise ...
The poiseuille (symbol Pl) has been proposed as a derived SI unit of dynamic viscosity, [1] named after the French physicist Jean Léonard Marie Poiseuille (1797–1869).. In practice the unit has never been widely accepted and most international standards bodies do not include the poiseuille in their list of units.
By definition, 1 reyn = 1 lb f s in −2.. It follows that the relation between the reyn and the poise is approximately . 1 reyn = 6.89476 × 10 4 P.. In SI units, viscosity is expressed in newton-seconds per square meter, or equivalently in pascal-seconds.
A number of different units (some only of historical interest) are shown and expressed in terms of the corresponding SI unit. Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article.
A Newtonian fluid is a power-law fluid with a behaviour index of 1, where the shear stress is directly proportional to the shear rate: = These fluids have a constant viscosity, μ, across all shear rates and include many of the most common fluids, such as water, most aqueous solutions, oils, corn syrup, glycerine, air and other gases.
It has dimensions (mass / (length × time)), and the corresponding SI unit is the pascal-second (Pa·s). Like other material properties (e.g. density, shear viscosity, and thermal conductivity) the value of volume viscosity is specific to each fluid and depends additionally on the fluid state, particularly its temperature and pressure.