Search results
Results from the WOW.Com Content Network
Wire drawing is a metalworking process used to reduce the cross-section of a wire by pulling the wire through one or more dies. There are many applications for wire drawing, including electrical wiring, cables, tension-loaded structural components, springs, paper clips, spokes for wheels, and stringed musical instruments.
Location of Texas. Texas is a state in the South Central region of the United States. The region's second-quarter 2018 gross state product was 8.6% of the GDP of the country at $1.755 trillion, with significant growth in mining, quarrying, and oil and gas extraction. [1]
For wire, bar, and tube drawing, the starting stock is drawn through a die to reduce its diameter and increase its length. Drawing is usually performed at room temperature, thus classified as a cold working process; however, drawing may also be performed at higher temperatures to hot work large wires, rods, or hollow tubes in order to reduce ...
A wire-cut EDM machine using the CNC drawing plotter and optical line follower techniques was produced in 1974. Dulebohn later used the same plotter CNC program to directly control the EDM machine, and the first CNC EDM machine was produced in 1976. [10] Commercial wire EDM capability and use has advanced substantially during recent decades. [11]
R. G. LeTourneau founded R.G. LeTourneau, Inc. in California in 1929, as a contractor of earthmoving equipment, which manufactured products in Longview, Texas. [1] [better source needed] During World War II, the company provided nearly 75% of the Allies' earthmoving equipment. [2] In 1954, it built the first jack-up drilling rig.
A fish tape (also called a draw wire, draw tape, or an electrician ' s snake) is a tool used by electricians to route new wiring through walls and electrical conduit. [ 1 ] Made of a narrow band of spring steel , by careful manipulation, the tape can be guided through confined spaces such as wall cavities or conduits in many countries.
This must be done because drawing wire hardens it, which causes the wire to become brittle. Brittle wire that has not been annealed may snap during the drawing process (or develop microscopic or macroscopic cracks, which may weaken the piece or "grow" with further working). With a mandrel, a draw plate can be used to draw tubes of metal. Plates ...
Both apparatus types have an adjustable drawing-head with rules attached to a protractor scale so that the angle of the rules may be adjusted. [6]: 35–36 A drafting machine allows easy drawing of parallel lines over the paper. The adjustable angle between the rulers allows the lines to be drawn in varying accurate angles.