Search results
Results from the WOW.Com Content Network
Stranded 22AWG jump wires with solid tips. A jump wire (also known as jumper, jumper wire, DuPont wire) is an electrical wire, or group of them in a cable, with a connector or pin at each end (or sometimes without them – simply "tinned"), which is normally used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other equipment or components ...
Ready-to-use jump wires come in different qualities, some even with tiny plugs attached to the wire ends. Jump wire material for ready-made or homemade wires should usually be 22 AWG (0.33 mm 2) solid copper, tin-plated wire - assuming no tiny plugs are to be attached to the wire ends. The wire ends should be stripped 3 ⁄ 16 to 5 ⁄ 16 in (4 ...
These wires are called wire bridges or jumpers, but unlike jumpers used for configuration settings, they are intended to permanently connect the points in question. They are used to solve layout issues of the printed wiring, providing connections that would otherwise require awkward (or in some cases, impossible) routing of the conductive traces.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
Video In Video Out, usually seen as the acronym VIVO (commonly pronounced vee-voh), is a graphics card port which enables some video cards to have bidirectional (input and output) video transfer through a Mini-DIN, usually of the 9-pin variety, and a specialised splitter cable (which can sometimes also transfer sound).
Historically this could be literally a breadboard, a wooden board with components attached to it and joined up with wire. More recently the term is applied to a board of thin insulating material with holes at standard 0.1-inch pitch; components are pushed through the holes to anchor them, and point-to-point wired on the other side of the board.
Jumper cables are electric cables to connect two rail or road vehicles. Jumper cable may also refer to: Jump wire, a short electrical wire with a solid tip at each end used to interconnect the components in a breadboard; Jumper cable (vehicle), a pair of electrical cables used to jump start a vehicle
Alligator clip A crocodile clip manufactured by Mueller Electric. This device is a variation of Dusinberre's original crocodile clip design Crocodile clips, also called automotive clips, on a set of jumper cables Three crocodile clips: a bare standard-sized clip; a miniature clip in a yellow plastic boot; a large red Square D multi-function clip