Ads
related to: gunter's chain measurements weight distribution ball mount hitches for trucks
Search results
Results from the WOW.Com Content Network
A quarter chain, or 25 links, measures 16 feet 6 inches (5.03 m) and thus measures a rod (or pole). Ten chains measure a furlong and 80 chains measure a statute mile. [1] Gunter's chain reconciled two seemingly incompatible systems: the traditional English land measurements, based on the number four, and decimals based on the number 10.
The UK statute chain is 22 yards, which is 66 feet (20.1168 m). This unit is a statute measure in the United Kingdom, defined in the Weights and Measures Act 1985. [6] One link is a hundredth part of a chain, which is 7.92 inches (20.1168 cm).
The trailer hitch ball attaches to a ball mount; with a diameter typically 1 ⁄ 16 inch (1.6 mm) larger than the ball bolt/shank diameter. [2] The ball mount must match the SAE hitch class. [3] The ballmount for a receiver-type hitch is a square bar that fits into a receiver attached to the vehicle.
American surveyors use a decimal-based system of measurement devised by Edmund Gunter in 1620. The base unit is Gunter's chain of 66 feet (20 m) which is subdivided into 4 rods, each of 16.5 ft or 100 links of 0.66 feet. A link is abbreviated "lk", and links "lks", in old deeds and land surveys done for the government.
An axlebox, also known as a journal box in North America, is the mechanical subassembly on each end of the axles under a railway wagon, coach or locomotive; it contains bearings and thus transfers the wagon, coach or locomotive weight to the wheels and rails; the bearing design is typically oil-bathed plain bearings on older rolling stock, or roller bearings on newer rolling stock.
The link (usually abbreviated as "l.", "li." or "lnk."), sometimes called a Gunter’s link, is a unit of length formerly used in many English-speaking countries. In US customary units modern definition, the link is exactly 66 ⁄ 100 of a US survey foot , [ 1 ] or exactly 7.92 inches or 20.1168 cm.
Adjustable three-point ball on lift arm. Ball may be rotated to fit either Category I or Category II implements Rear three-point hitch of a Case IH tractor with implement attached by the drawbar. There are five different hitch sizes, called categories. The higher category hitches have sturdier lift arms and larger connector pins. [2]
The trucker's hitch is a compound knot commonly used for securing loads on trucks [7] or trailers. The general arrangement, using loops and turns in the rope itself to form a crude block and tackle , has long been used to tension lines and is known by multiple names.
Ads
related to: gunter's chain measurements weight distribution ball mount hitches for trucks