enow.com Web Search

  1. Ads

    related to: phillips head screw size chart

Search results

  1. Results from the WOW.Com Content Network
  2. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

  3. Robertson screw - Wikipedia

    en.wikipedia.org/wiki/Robertson_screw

    Many screws used in electrical applications (for example, a typical NEMA 5-15R, breaker screws, and conduit screws) use a combination of a slotted/Phillips/Robertson screw head. A few tool manufacturers make bits to engage this screw head better than the traditional Phillips allowing for more torque before camout, for example, the C1 and C2 ...

  4. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    A socket cap screw, also known as a socket head capscrew, socket screw, or Allen bolt, is a type of cap screw with a cylindrical head and hexagonal drive hole. The term socket head capscrew typically refers to a type of threaded fastener whose head diameter is nominally 1.5 times that of the screw shank ( major ) diameter, with a head height ...

  5. Screw - Wikipedia

    en.wikipedia.org/wiki/Screw

    In the early 1930s American Henry F. Phillips popularized the Phillips-head screw, with a cross-shaped internal drive. [27] Later improved -head screws were developed, more compatible with screwdrivers not of the exactly right head size: Pozidriv and Supadriv. Phillips screws and screwdrivers are to some extent compatible with those for the ...

  6. Henry F. Phillips - Wikipedia

    en.wikipedia.org/wiki/Henry_F._Phillips

    Phillips screw head. Henry Frank Phillips (June 4, 1889 – April 13, 1958) was an American businessman from Portland, Oregon. The Phillips-head ("crosshead") screw and screwdriver are named after him. [1] The importance of the crosshead screw design lies in its self-centering property, useful on automated production lines that use powered ...

  7. Screwdriver - Wikipedia

    en.wikipedia.org/wiki/Screwdriver

    The cross in the screw head is sharper and less rounded than a Phillips, and the bit has 45° flukes and a sharper, pointed end. Also, the Phillips screw slot is not as deep as the Reed and Prince slot. [19] [20] In theory, different size R&P screws fit any R&P bit size. [21]

  1. Ads

    related to: phillips head screw size chart