Ad
related to: level iiia soft armor panels installation guide
Search results
Results from the WOW.Com Content Network
The VPAM scale as of 2009 runs from 1 to 14, with 1-5 being soft armor, and 6-14 being hard armor. [1] Tested armor must withstand three hits, spaced 120 mm (4.7 inches) apart, of the designated test threat with no more than 25 mm (0.98 inches) of back-face deformation in order to pass.
The vest consists of front and rear panels with pockets for BALCS or SPEAR-cut soft armor panels and standard-issue SAPI (Small Arms Protective Insert) plates. This gives the wearer up to NIJ Level IV protection on the front and back and Level IIIA protection on the sides.
A level IIIA soft armor low-profile vest. Modern body armor is generally split into one of two categories: soft armor and hard armor. Soft armor is typically made of woven fabrics, like Dyneema or Kevlar, and usually provides protection against fragmentation and handgun threats.
The flexible soft armor vest panels consist of an aramid (Kevlar KM2) filler encased in a nylon Woodland camouflage-printed carrier. The vest weighs approximately 8 pounds in size medium, and provides ballistic protection to Threat Level IIIA according to the NIJ Body Armor Classification.
A call for a next generation plate, to stop even greater velocity threats than the ESAPI plate was issued by the U.S. Army in 2008. [5] The X Threat Small Arms Protective Insert plates are specifically allowed scalar or flexible systems, and asked for better coverage, with less than a pound of additional weight.
The soft kevlar panels have been tested to stop 9 mm 124 grain full metal jacket bullets at 1,400 ft/s (426 m/s) with minimal deformation and has a V-50 of roughly 1,525 ft/s (465 m/s). This means that the bullet has to be traveling faster than 1,525 ft/s (465 m/s) for it to have more than a 50% chance of breaking through the soft armor panel.
HG (Hand Gun) is for soft armor and RF (Rifle) is for hard armor. Another important change is that the test-round velocity for conditioned armor will be the same as that for new armor during testing. For example, for NIJ Standard-0101.06 Level IIIA the .44 Magnum round is currently shot at 408 m/s (1,340 ft/s) for conditioned armor and at 436 m ...
The level of protection can be increased or decreased depending on the threat environment by adding or removing soft armour pads and hard ballistic plates. Unlike the Osprey's Velcro straps, the Virtus has a chest-positioned pin quick-release mechanism that releases the entire body kit when pulled for safe extraction in hazardous situations.
Ad
related to: level iiia soft armor panels installation guide