enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Snow anchor - Wikipedia

   en.wikipedia.org/wiki/Snow_anchor

   A snow anchor is used both for climbing and for securing tents and other camping gear, that is designed for use in sand and snow. A snow fluke is a bent square or rectangle, approximately 8 by 10 inches (20 by 25 cm), and is made of aluminum or other metal, with a cable attached at two points on the upper surface. [ 1 ]

3. Guy-wire - Wikipedia

   en.wikipedia.org/wiki/Guy-wire

   This type consists of a rod with wide screw blades on the end and an eyelet on the other for the guy wire. It is screwed deep into the ground, at the same angle as the guy, by a truck-mounted drill machine. These are commonly used as guy anchors for utility poles since they are quick to install with a truck mounted hydraulic powered auger drive.

4. Tent peg - Wikipedia

   en.wikipedia.org/wiki/Tent_peg

   A tent peg (or tent stake) is a spike, usually with a hook or hole on the top end, typically made from wood, metal, plastic, or composite material, pushed or driven into the ground for holding a tent to the ground, either directly by attaching to the tent's material, or by connecting to ropes attached to the tent. Traditionally, a tent peg is ...

5. Tent - Wikipedia

   en.wikipedia.org/wiki/Tent

   Stakes (or tent pegs) or screws may be used to fasten the tent to the ground. Some are attached to guy ropes that pull outward on the poles and/or fabric to help shape the tent or give it additional stability. Others are used to anchor the bottom edge of the fabric to the ground. Pegs may be made of wood, plastic, or metal.

6. Taut-line hitch - Wikipedia

   en.wikipedia.org/wiki/Taut-line_hitch

   Adjusting the guy-lines of a tent is a common use for the taut-line hitch. Once snug and set, the hitch can be adjusted as needed. To tighten the line with respect to a load attached to the standing part, the user can grasp the standing part with one hand inside of the loop and pull toward the anchor object.

7. Ice screw - Wikipedia

   en.wikipedia.org/wiki/Ice_screw

   An ice screw. Some modern screws like this one now have a handle to assist entry and removal, whereas early models did not. An ice screw is a threaded tubular screw used as a running belay or anchor by climbers on steep ice surface such as steep waterfall ice or alpine ice during ice climbing or crevasse rescue, to hold the climber in the event of a fall, and at belays as anchor points.

8. Piton - Wikipedia

   en.wikipedia.org/wiki/Piton

   1960s-era pitons, including: knifeblades, lost arrows, bugaboos, ring angles, and bongs. A piton (/ ˈ p iː t ɒ n /; also called pin or peg) in big wall climbing and in aid climbing is a metal spike (usually steel) that is driven into a crack or seam in the climbing surface using a climbing hammer, and which acts as an anchor for protecting the climber from falling or to assist progress in ...

9. Screw picket - Wikipedia

   en.wikipedia.org/wiki/Screw_picket

   A screw picket is a metal device which is used to secure objects to the ground. Today, screw pickets are used widely to temporarily "picket" dogs. They are also used to graze animals such as sheep, goats, and horses. Screw pickets are also used to stabilize small trees, tent poles, and other objects that are intended to remain upright.