enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   Top: an assembled keyless chuck. This type of chuck is tightened by twisting the body using firm hand pressure only. While convenient, this feature can cause the chuck to tighten too much when high torque is applied. Bottom: the widely used keyed type of drill chuck with its key. The arbor is shown separately to the right. These chucks require ...

3. Key (engineering) - Wikipedia

   en.wikipedia.org/wiki/Key_(engineering)

   However, it can produce the most accurate keyway out of all the processes. There are three main steps in broaching a keyway: First, the workpiece is set on the arbor press and the bushing is placed in the opening of the workpiece. Next, the broach is inserted and pushed through, cutting the keyway.

4. Magnetic drilling machine - Wikipedia

   en.wikipedia.org/wiki/Magnetic_drilling_machine

   The arbor or chuck on a magnetic drill is attached to the motor. It is a type of clamp used to attach the core drills. There are mainly two types of chuck available for the magnetic drill, industrial arbor (manual tightening) and quick change drill chucks. The quick change drill chucks are easy and fast option to attach the core drills.

5. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Drill chucks mounted by Jacobs tapers onto arbors with Morse tapers for the spindle. Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut.

6. Senator Warren wants US military to fix its own equipment - AOL

   www.aol.com/news/senator-warren-wants-us...

   Proposed amid a cost-cutting push by President-elect Donald Trump, Warren's bill would make contractors give the military "fair and reasonable access" to parts, tools and repair instructions.

7. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.