Search results
Results from the WOW.Com Content Network
Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...
An automotive belt with the number "740K6" or "6K740" indicates a belt 74 inches (190 cm) in length, 6 ribs wide, with a rib pitch of 9 ⁄ 64 of an inch (3.6 mm) (a standard thickness for a K series automotive belt would be 4.5mm). A metric equivalent would be usually indicated by "6PK1880" whereby 6 refers to the number of ribs, PK refers to ...
A flat belt has an effective angle of =. The material of a V-belt or multi-V serpentine belt tends to wedge into the mating groove in a pulley as the load increases, improving torque transmission. [6] For the same power transmission, a V-belt requires less tension than a flat belt, increasing bearing life. [5]
Dayco Incorporated, formerly known as Dayco Products and Mark IV Industries, is an American parts supplier for construction, automotive, and industrial companies. [1] The companies annual earnings are approximately US$150 million. [ 1 ]
Aside from the belt/chain itself, also common is a failure of the tensioner, and/or the various gear and idler bearings, causing the belt/chain to derail. Furthermore, in engines where the timing belt drives the water pump, failure of the water pump can cause the pump to seize, which can break the timing belt or chain.
These diagrams can be used to easily determine the type, size, and material of a member in a structure so that a given set of loads can be supported without structural failure. Another application of shear and moment diagrams is that the deflection of a beam can be easily determined using either the moment area method or the conjugate beam method.
The belt problem. The belt problem is a mathematics problem which requires finding the length of a crossed belt that connects two circular pulleys with radius r 1 and r 2 whose centers are separated by a distance P. The solution of the belt problem requires trigonometry and the concepts of the bitangent line, the vertical angle, and congruent ...
The medium size individual equipment belt (NSN 8465-00-001-6488) is for soldiers with waists measuring under 30 inches (76 cm) and size large (NSN 8465-00-001-6487) is for those with waists measuring 30 inches (76 cm) or over. The length of the belt is adjusted at each end by means of adjusting clamps which slide along the belt when opened. [3]