Search results
Results from the WOW.Com Content Network
A later, modified version of the Type 2 connector which includes two additional DC current pins at the base to allow for high-power (up to 350kW) DC fast charging, is known as a Combined Charging System (CCS) Combo 2 plug, and has also been adopted as an EU standard.
From left: IEC Type 1/SAE J1772 inlet; Tesla NACS outlet; IEC Type 2 connector outlet IEC 62196 Plugs, socket-outlets, vehicle connectors and vehicle inlets – Conductive charging of electric vehicles is a series of international standards that define requirements and tests for plugs, socket-outlets, vehicle connectors and vehicle inlets for conductive charging of electric vehicles and is ...
In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.
ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.
A controller area network (CAN) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts.
This practice arose from the three-wire system used to supply both 120 volt and 240 volt loads. Because these listed appliances often have components that use either 120, or both 120 and 240 volts, there is often some current on the neutral wire. This differs from the protective grounding wire, which only carries current under fault conditions.
The plug for SAE J560 is physically identical to the connector ISO 1185. The difference is that J560 indicates that the voltage must be 12 V and that wire areas shall be larger due to the higher currents needed when using 12 V compared to 24 V. Some of the pins in the connector have also a slightly different function.
The non-tripped state is typically 24 VDC, and the tripped state (when the safety barrier has been violated) 0 VDC. If a wire were to break between the light curtain and the safety relay, the safety relay would trip to the safe state. The OSSD outputs are self-checked. In the non-tripped state, the outputs periodically pulse low.