Search results
Results from the WOW.Com Content Network
A tracer-gas leak testing method is a nondestructive testing method that detects gas leaks.A variety of methods with different sensitivities exist. Tracer-gas leak testing is used in the petrochemical industry, the automotive industry, the construction industry [1] and in the manufacture of semiconductors, among other uses.
The primary purpose of leak detection systems (LDS) is to help pipeline controllers to detect and localize leaks. LDS provide alarms and display other related data to the pipeline controllers to assist decision-making. Pipeline leak detection systems can also enhance productivity and system reliability thanks to reduced downtime and inspection ...
Tank leak detection is implemented to alert the operator to a suspected release from any part of a storage tank system, what enables to prevent from soil contamination and loss of product. In many countries regulated UST are required to have an approved leak detection method so that leaks are discovered quickly and the release is stopped in time.
A gas leak refers to a leak of natural gas or another gaseous product from a pipeline or other containment into any area where the gas should not be present. Gas leaks can be hazardous to health as well as the environment. Even a small leak into a building or other confined space may gradually build up an explosive or lethal gas concentration. [1]
A detector for propane is best placed down low near the floor, as propane is heavier than air. [3] A detector for natural gas (city gas) is best placed up high, near the ceiling. [3] Some detectors can detect both natural gas or propane, but this requires a compromise location. [4]
Compared to the helium test, hydrogen is cheaper than helium, no need for a vacuum, the instrument could be cheaper but is not as sensitive as a helium leak detector so will not find smaller leaks. Chemo-chromic hydrogen leak detectors are materials that can be proactively applied to a connection or fitting. In the event of a hydrogen leak, the ...
Helium is used as a tracer because it penetrates small leaks rapidly. Helium also has the properties of being non-toxic, chemically inert and present in the atmosphere only in minute quantities (5 ppm). Typically a helium leak detector will be used to measure leaks in the range of 10 −5 to 10 −12 Pa·m 3 ·s −1.
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...