Search results
Results from the WOW.Com Content Network
Electrical equipment may be designed with a floating ground for one of several reasons. One is safety. For example, a low-voltage DC power supply, such as a mobile phone charger, is connected to the mains through a transformer of one type or another, and there is no direct electrical connection between the current return path on the low-voltage side and physical ground (earth).
The circuit is closely related to the gated D latch as both the circuits convert the two D input states (0 and 1) to two input combinations (01 and 10) for the output SR latch by inverting the data input signal (both the circuits split the single D signal in two complementary S and R signals).
Battery-powering one or more of the circuits can avoid a ground loop, because the entire device may be disconnected from mains power. A hazardous technique sometimes used by amateurs is to break the third wire ground conductor P in one of the component's power cords, by removing the ground pin on the plug, or using a cheater plug .
Like the floating gate memory cell, a charge trapping cell uses a variable charge between the control gate and the channel to change the threshold voltage of the transistor. The mechanisms to modify this charge are relatively similar between the floating gate and the charge trap, and the read mechanisms are also very similar.
Single-ended, floating common. An isolated and quasi-balanced input (the floating common is typically connected to the (-) input of a differential amplifier). Suitable for off-ground measurements up to the breakdown voltage of the isolation barrier, and exhibits very good common mode rejection (100 db typical). Differential, floating common.
In 1967, Fairchild introduced the first ALU-like device implemented as an integrated circuit, the Fairchild 3800, consisting of an eight-bit arithmetic unit with accumulator. It only supported adds and subtracts but no logic functions. [8] Full integrated-circuit ALUs soon emerged, including four-bit ALUs such as the Am2901 and 74181.
Dual-loop is a method of electrical circuit termination used in electronic security applications, particularly modern intruder alarms. It is called 'dual-loop' because two circuits (alarm and anti-tamper) are combined into one using resistors. Its use became widespread in the early 21st century, replacing the basic closed-circuit system, mainly ...
The effective voltage applied to the op-amp input is floating so the op-amp must have a differential input. The circuit is named inverting since the output voltage always has an opposite sign to the input voltage when it is out of the hysteresis cycle (when the input voltage is above the high threshold or below the low threshold). However, if ...