Search results
Results from the WOW.Com Content Network
The first Y-block on Ford automobiles and F100 trucks was the 239 cu in (3,910 cc) version as released in 1954 with EBU casting numbers. The Y-block was the same displacement as the old Ford Flathead V8 that it replaced but with a bigger bore and a shorter stroke (3.5 x 3.1 in).
Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some "big block"-sized V8's as well as some V6's and I6's. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8; 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block; 302 Cleveland (Australia)
It offers the airflow of more expensive heads, at a much lower cost. It does, however, require a specific intake manifold (the L31 has four bolts per head attaching the intake manifold, as opposed to the "traditional" six bolts per head found on older Chevrolet small-blocks). Chevrolet's L31 was replaced by GM's LS-based 5.3L LM7 and 6.0L LQ4.
The low-rise intake, designed to fit under a low hoodline, was the first. The high-rise intake required a hood bubble for clearance. While the low- and medium-rise heads could be used in combination with either low- or medium-rise intakes, the high-rise head required a high-rise intake due to the increased height of the intake port.
In order to be "matched" all sprinkler heads in a given zone must have the same rate of precipitation. This can be achieved by matching the gallonage of a standard rotor to its arc and reducing range accordingly (i.e. 2 gallons at 90 degrees, 4 gallons at 180 degrees, or 8 gallons if the head does a full circle) or by using MPR nozzles or ...
All generation-2 small-block Olds V8s used the same stroke of 3.385 in (86 mm). The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material ...
A fire sprinkler mounted on a ceiling. A fire sprinkler or sprinkler head is the component of a fire sprinkler system that discharges water when the effects of a fire have been detected, such as when a predetermined temperature has been exceeded. Fire sprinklers are extensively used worldwide, with over 40 million sprinkler heads fitted each year.
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...