Search results
Results from the WOW.Com Content Network
Though the pre-3800 rear-wheel drive (RWD) V6 uses the Buick, Oldsmobile, Pontiac (BOP) bellhousing pattern, an oddity of both the front-wheel drive (FWD) and RWD 3800 V6 is that although it is a 90° V6, it uses the GM 60° V6 bell housing (Metric Pattern). For use in the FWD applications, the bellhousings on the FWD transmissions are altered ...
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present.
1962–2009 Buick V6 (marketed as "Fireball V6", "3800", "Dauntless V6" in 1966-1971 Jeeps, and "Ecotec" in Holdens) 1977–2013 Chevrolet 90° V6 engine (derived from the Chevrolet Small-Block" V8; now marketed as GM Vortec V6 or Vortec 4300 or EcoTec3 V6) 1979–2010 Chevrolet 60-Degree V6
The Lucerne replaced the full-size LeSabre and the Park Avenue in the Buick range, and used a revised G platform, nonetheless referred to by GM as the H platform. [1]The Lucerne was introduced with the standard 3.8 liter Buick V6 (also known as the GM 3800 engine) or optional 4.6 liter Cadillac Northstar LD8 V8 as well as optional active suspension, marketed as Magnetic Ride Control.
The Chevrolet 90° V6 family of V6 engines began in 1978 with the Chevrolet 200 cu in (3.3 L) as the base engine for the all new 1978 Chevrolet Malibu.The original engine family was phased out in early 2014, with its final use as the 4.3 L (262 cu in) V6 engine used in Chevrolet and GMC trucks and vans.
The LQ1 (also called the Twin Dual Cam or TDC) was a 3.4 L (3,350 cc) DOHC V6 engine ("X-code") based on the aluminum-headed second generation of GM's 60° engine line, sharing a similar block with its pushrod cousins, the 3.1 L LH0 V6 and the then recently retired 2.8 L (2,837 cc) LB6 V6.
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.