Search results
Results from the WOW.Com Content Network
The Radio Resource Control (RRC) protocol is used in UMTS, LTE and 5G on the Air interface. It is a layer 3 (Network Layer) protocol used between UE and Base Station. This protocol is specified by 3GPP in TS 25.331 [2] for UMTS, in TS 36.331 [3] for LTE and in TS 38.331 [4] for 5G New Radio. RRC messages are transported via the PDCP-Protocol.
The Radio Network Controller (RNC) is a governing element in the UMTS radio access network and is responsible for controlling the Node Bs that are connected to it. The RNC carries out radio resource management, some of the mobility management functions and is the point where encryption is done before user data is sent to and from the mobile.
This is a list of commands from the GNU Core Utilities for Unix environments. These commands can be found on Unix operating systems and most Unix-like operating systems. GNU Core Utilities include basic file, shell and text manipulation utilities. Coreutils includes all of the basic command-line tools that are expected in a POSIX system.
Radio resource management (RRM) is the system level management of co-channel interference, radio resources, and other radio transmission characteristics in wireless communication systems, for example cellular networks, wireless local area networks, wireless sensor systems, and radio broadcasting networks.
The command syntax shows some characters in a mixture of upper and lower case. Abbreviating the command to only sending the upper case has the same meaning as sending the upper and lower case command. [3] For example, the command “SYSTem:COMMunicate:SERial:BAUD 2400” would set an RS-232 serial communications interface to 2400 bit/s.
The clients can issue commands to the control daemon, which would accept and divide the workload to the computing daemons. For clients, the main commands are srun (queue up an interactive job), sbatch (queue up a job), squeue (print the job queue) and scancel (remove a job from the queue). Jobs can be run in batch mode or interactive mode. For ...
Support for command history means that a user can recall a previous command into the command-line editor and edit it before issuing the potentially modified command. Shells that support completion may also be able to directly complete the command from the command history given a partial/initial part of the previous command.
In Linux, the parameter is called net.ipv4.ip_forward. In most systems, the command sysctl -w parameter=1 will enable a certain behavior. This will persist until the next reboot. If the behavior should be enabled whenever the system boots, the line parameter=1 can be added/rewritten to the file /etc/sysctl.conf. Additionally, some sysctl ...