enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Scrubber (brush) - Wikipedia

   en.wikipedia.org/wiki/Scrubber_(brush)

   A scrubber (German: Schrubber), is a type of wide brush with a long shaft used for cleaning hard floors or surfaces. Unlike a broom, which has soft bristles to sweep dirt away, a scrubber has hard bristles for brushing. It may therefore be used wet, with water or cleaning fluids.

3. Floor scrubber - Wikipedia

   en.wikipedia.org/wiki/Floor_scrubber

   A floor scrubber. A floor scrubber is a floor cleaning device. It can be a simple tool such as a floor mop or floor brush, or in the form of a walk-behind or a ride-on machine to clean larger areas by injecting water with cleaning solution, scrubbing, and lifting the residue off the floor.

4. Best Garden Hoses for Lawn and Garden Upkeep - AOL

   www.aol.com/best-garden-hoses-more-just...

   We evaluated these 10 garden hoses—for durability, water flow, kink-resistance, and weight. These are the best for your garden, farm, garage, RV, and more.

5. Vacuum cleaner - Wikipedia

   en.wikipedia.org/wiki/Vacuum_cleaner

   The suction is the maximum pressure difference that the pump can create. For example, a typical domestic model has a suction of about negative 20 kPa. [citation needed] This means that it can lower the pressure inside the hose from normal atmospheric pressure (about 100 kPa) by 20 kPa. The higher the suction rating, the more powerful the cleaner.

6. Peristaltic pump - Wikipedia

   en.wikipedia.org/wiki/Peristaltic_pump

   The biggest advantage with the hose pumps over the roller pumps is the high operating pressure of up to 16 bar. With rollers, max pressure can arrive up to 12 bar (170 psi) without any problem. If the high operating pressure is not required, a tubing pump is a better option than a hose pump if the pumped medium is not abrasive.

7. Brush - Wikipedia

   en.wikipedia.org/wiki/Brush

   A common way of setting the bristles, brush filaments, in the brush is the staple or anchor set brush in which the filament is forced with a staple by the middle into a hole with a special driver and held there by the pressure against all of the walls of the hole and the portions of the staple nailed to the bottom of the hole.