enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ignition coil - Wikipedia

   en.wikipedia.org/wiki/Ignition_coil

   An ignition coil is used in the ignition system of a spark-ignition engine to transform the battery voltage to the much higher voltages required to operate the spark plug(s). The spark plugs then use this burst of high-voltage electricity to ignite the air-fuel mixture. The ignition coil is constructed of two sets of coils wound around an iron ...

3. Spark plug - Wikipedia

   en.wikipedia.org/wiki/Spark_plug

   Spark plug with single side electrode An electric spark on the spark plug. A spark plug (sometimes, in British English, a sparking plug, [1] and, colloquially, a plug) is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture by an electric spark, while containing combustion pressure within ...

4. Cylinder Head Temperature gauge - Wikipedia

   en.wikipedia.org/wiki/Cylinder_Head_Temperature...

   The ring under the spark plug is used to transfer the heat from the plug to the thermocouple. The gauge and cold junction are usually calibrated at room temperature, 72 °F (22 °C). Because the thermocouple is calibrated for room temperature, the gauge readings will only be 100% accurate at that engine compartment temperature.

5. Capacitor discharge ignition - Wikipedia

   en.wikipedia.org/wiki/Capacitor_discharge_ignition

   Since the CDI system provides only a reduced duration spark, it's also possible to combine this ignition system with ionization measurement. This is done by connecting a low voltage (about 80 V) to the spark plug, except when fired. The current flow over the spark plug can then be used to calculate the temperature and pressure inside the cylinder.

6. Ignition system - Wikipedia

   en.wikipedia.org/wiki/Ignition_system

   A variation coil-on-plug ignition has each coil handle two plugs, on cylinders which are 360 degrees out of phase (and therefore reach top dead center (TDC) at the same time); in the four-cycle engine this means that one plug will be sparking during the end of the exhaust stroke while the other fires at the usual time, a so-called "wasted spark ...

7. Spark gap - Wikipedia

   en.wikipedia.org/wiki/Spark_gap

   A spark plug.The spark gap is at the bottom. A spark plug uses a spark gap to initiate combustion.The heat of the ionization trail, but more importantly, UV radiation and hot free electrons (both cause the formation of reactive free radicals) [citation needed] ignite a fuel-air mixture inside an internal combustion engine, or a burner in a furnace, oven, or stove.

8. Spark plug wires - Wikipedia

   en.wikipedia.org/wiki/Spark_plug_wires

   Spark plug wires (also called high tension leads) are electrical cables used by older internal combustion engines to transmit high-voltage electricity from the distributor to the spark plugs. Tension in this instance is a synonym for voltage. High tension may also be referred to as HT. [1] Many modern engines use coil-on-plug ignition, a design ...

9. Pre-ignition - Wikipedia

   en.wikipedia.org/wiki/Pre-ignition

   Carbon deposits form a heat barrier and can be a contributing factor to pre-ignition. Other causes include: An overheated spark plug (too hot a heat range for the application). Glowing carbon deposits on a hot exhaust valve (which may mean the valve is running too hot because of poor seating, a weak valve spring or insufficient valve lash)