Search results
Results from the WOW.Com Content Network
At 10 000 ppm the solution is a deep red colour. As the concentration decreases the colour becomes orange, then a vibrant yellow, with the final 1 ppm sample a very pale yellow. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...
PM is most usually (but not always) expressed as mg/m 3 of air or other gas at a specified temperature and pressure. For gases, volume percent = mole percent; 1 volume percent = 10,000 ppmv (i.e., parts per million by volume) with a million being defined as 10 6.
If a gaseous emission sample is analyzed and found to contain water vapor and a pollutant concentration of say 40 ppmv, then 40 ppmv should be designated as the "wet basis" pollutant concentration. The following equation can be used to correct the measured "wet basis" concentration to a " dry basis " concentration: [ 3 ]
Its units are in parts per million (ppm) for gases and in milligrams per cubic meter (mg/m 3) for particulates such as dust, smoke and mist. The basic formula for converting between ppm and mg/m 3 for gases is ppm = (mg/m^3) * 24.45 / molecular weight. This formula is not applicable to airborne particles.
14] Water can be classified by the level of total dissolved solids (TDS) in the water: Fresh water: TDS is less than 1,000 ppm. Brackish water: TDS = 1,000 to 10,000 ppm. Saline water: TDS = 10,000 to 35,000 ppm. Hypersaline: TDS greater than 35,000 ppm. Drinking water generally has a TDS below 500 ppm.
For a dilute solution, such as NaCl in water, concentration is often expressed as weight of solute divided by mass of solution (typically assuming 1 g/mL for dilute water-based solutions) -- i.e., ppm by weight. Mass/volume notation such as micrograms/mL is also used for liquid solutions. Low concentrations of pollutant gases in air are often ...
Intake fraction is the total mass of a pollutant ingested or inhaled by all exposed individuals over a given time, per total mass of the pollutant emitted. The intake fraction can be divided into components that identify the specific pollutant source, route, media, and subpopulation of exposed individuals.
Typically anhydrous solvents will contain approximately 10 ppm of water and will increase in wetness if they are not properly stored. Organic solutions can be dried using a range of drying agents. Typically following a workup the organic extract is dried using magnesium sulfate or a similar drying agent to remove most remaining water. [5]