Search results
Results from the WOW.Com Content Network
Hip, hipped: A hipped roof is sloped in two pairs of directions (e.g. N–S and E–W) compared to the one pair of direction (e.g. N–S or E–W) for a gable roof. Cross hipped: The result of joining two or more hip roof sections together, forming a T or L shape for the simplest forms, or any number of more complex shapes.
Degree indicates the angle in degrees from 0° to 90°. Common indicates the rise in inches over a 12 inch run for common rafters from 1 inch to 30 inch. Hip/Val indicates the rise in inches over a 17 inch run for hip or valley rafters from 1 inch to 30 inch. Some models have divots for fitting a writing utensil to mark lumber with.
Speed square, or rafter square, or rafter angle square, or triangle square, or layout square A speed square is a triangular carpenters square combining functions of the combination square, try square, and framing square into one. It can be used to calculate and mark angles, to suspend a plumb bob, and as a fence for a circular saw. [21] [22] [23]
The dragon beam lies parallel to and below a hip rafter and carries the rafter. The dragon beam is carried by the wall on the outer end and by a horizontal piece between the two walls on the inside end. There are conflicting usages for this term in the U.K. and U.S.A. (see below). The most common usage seems to be combination dragon beam/cross tie.
The hip or valley rafter also connects the ridge to the plate, but lies at a 45-degree angle to the common rafter. This number gives the length of the hip or valley rafter per seventeen units of run. Difference in lengths jacks. The jack rafters lie in the same plane as the common rafter but connect the top plate (the wall) or ridge board to ...
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
The "hips" and hip rafters sit on an external corner of the building and rise to the ridge. Where the building has an internal corner, a valley makes the join between the sloping surfaces (and is underlain by a valley rafter). Hip roofs have the advantage of giving a compact, solid appearance to a structure. The roof pitch (slope) may vary.
The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam , which has extra bracing to attach it to the rafters. The purlins are the large beams perpendicular to the rafters; from this shot, it appears that there are three purlins on either side of the roof.