Search results
Results from the WOW.Com Content Network
To illustrate the processes, consider the case of dissolving a weak acid, HA, in water. The pH can be calculated using an ICE table. Note that in this example, we are assuming that the acid is not very weak, and that the concentration is not very dilute, so that the concentration of [OH −] ions can be neglected. This is equivalent to the ...
This sodium hydroxide solution can be used to measure the equivalent weight of an unknown acid. For example, if it takes 13.20±0.03 cm 3 of the sodium hydroxide solution to neutralise 61.3±0.1 mg of an unknown acid, the equivalent weight of the acid is:
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: f eq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c(H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution.
The solution has 1 mole or 1 equiv Na +, 1 mole or 2 equiv Ca 2+, and 3 mole or 3 equiv Cl −. An earlier definition, used especially for chemical elements , holds that an equivalent is the amount of a substance that will react with 1 g (0.035 oz) of hydrogen , 8 g (0.28 oz) of oxygen , or 35.5 g (1.25 oz) of chlorine —or that will displace ...
The solvent (e.g. water) is omitted from the defining expression on the assumption that its concentration is very much greater than the concentration of dissolved acid, [H 2 O] ≫ T A. The equation for mass-balance in hydrogen ions can then be written as T H = [H +] + [A −][H +]/K a − K w / [H +]
V eq is the volume of titrant (ml) consumed by the crude oil sample and 1 ml of spiking solution at the equivalent point, b eq is the volume of titrant (ml) consumed by 1 ml of spiking solution at the equivalent point, 56.1 g/mol is the molecular weight of KOH, W oil is the mass of the sample in grams. The normality (N) of titrant is calculated as:
The hydroxyl value can be calculated using the following equation. Note that a chemical substance may also have a measurable acid value affecting the measured endpoint of the titration. The acid value ( AV ) of the substance, determined in a separate experiment, enters into this equation as a correction factor in the calculation of the hydroxyl ...
3 in solution represents 1 molar equivalent, while 1 mole of CO 2− 3 is 2 molar equivalents because twice as many H + ions would be necessary to balance the charge. The total charge of a solution always equals zero. [8] This leads to a parallel definition of alkalinity that is based upon the charge balance of ions in a solution.