Search results
Results from the WOW.Com Content Network
The analog input is 10-bit resolution for voltages varying between 0 V and 5 V. The digital output line outputs 0 V and 5 V at 20 mA and is capable of sending pulses and serial data. Each channel supports smart boards [11] to add serial communication for microcontrollers such as Arduino or BASIC Stamp, servo control, or X10 outlet and light ...
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...
The Arduino software includes a serial monitor which allows simple textual data to be sent to and from the Arduino board. The RX and TX LEDs on the board flash when data is being transmitted via the FTDI chip and the USB connection to the computer (but not for serial communication on pins 0 and 1).
Arduino layout-compatible board, designed for use with a USB-TTL serial cable. DuinoBot v1.x [79] RobotGroup Argentina [80] ATmega32U4 16 MHz Arduino fully compatible board, with integrated power supply and controllers designed for robotics. Compatible as well with the system "Multiplo" eJackino [81] Kit by CQ publisher in Japan.
SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.
The common serial interfaces are SPI, I²C, Microwire, UNI/O, and 1-Wire. These use from 1 to 4 device pins and allow devices to use packages with 8 pins or less. A typical EEPROM serial protocol consists of three phases: OP-code phase, address phase and data phase. The OP-code is usually the first 8 bits input to the serial input pin of the ...
It is sometimes called a four-wire serial bus to contrast with three-wire variants which are half duplex, and with the two-wire I²C and 1-Wire serial buses. Typical applications include interfacing microcontrollers with peripheral chips for Secure Digital cards, liquid crystal displays , analog-to-digital and digital-to-analog converters ...