Search results
Results from the WOW.Com Content Network
They are both required to be accessed through a standardized data link connector defined by SAE J1962. Heavy duty vehicles (greater than 14,000 lb or 6,400 kg) made after 2010, [1] for sale in the US are allowed to support OBD-II diagnostics through SAE standard J1939-13 (a round diagnostic connector) according to CARB in title 13 CCR 1971.1 ...
Unlike the OBD-I connector, which was sometimes found under the bonnet of the vehicle, the OBD-II connector is required to be within 2 feet (0.61 m) of the steering wheel (unless an exemption is applied for by the manufacturer, in which case it is still somewhere within reach of the driver). SAE J1962 defines the pinout of the connector as:
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
The J1587 protocol uses different diagnostic connectors. Up to 1995, individual OEMs used their own connectors. From 1996 to 2001, the 6-pin Deutsch-connector was standard. Beginning in 2001, most OEMs converted to the 9-pin Deutsch. Some OEMs still use the 6-pin Deutsch. It has mostly been used for US made vehicles, and also by Volvo.
The following model codes have been used by Toyota. The letters of the model code is found by combining the letters of the engine code with the platform code. The letters of the model code is found by combining the letters of the engine code with the platform code.
ALDL 12 pins connector - front view. Assembly Line Diagnostic Link, Assembly Line Data Link, or ALDL is a proprietary on-board diagnostics system developed by General Motors before the standardization of OBD-2. It was previously called Assembly Line Communications Link or ALCL. The two terms are used interchangeably.
SAE J1939 defines five layers in the seven-layer OSI network model, and this includes the Controller Area Network (CAN) ISO 11898 specification (using only the 29-bit/"extended" identifier) for the physical and data-link layers. Under J1939/11 and J1939/15, the data rate is specified as 250 kbit/s, with J1939/14 specifying 500 kbit/s.
OBD 1 vs OBD 2 the vehicle will also dictate what the scan tool is able to display. If the vehicle is equipped with OBD 1 it will have significantly less available data when compared to a vehicle equipped with OBD 2. [2] When a vehicle detects a problem, it generates a DTC code which is a unique code that corresponds to the specific problem ...