Search results
Results from the WOW.Com Content Network
A superabsorbent polymer (SAP) (also called slush powder) is a water-absorbing hydrophilic homopolymers or copolymers [1] that can absorb and retain extremely large amounts of a liquid relative to its own mass. [2] Water-absorbing polymers, which are classified as hydrogels when mixed, [3] absorb aqueous solutions through hydrogen bonding with ...
In materials science, liquefaction [1] is a process that generates a liquid from a solid or a gas [2] or that generates a non-liquid phase which behaves in accordance with fluid dynamics. [3] It occurs both naturally and artificially. As an example of the latter, a "major commercial application of liquefaction is the liquefaction of air to ...
It is a common observation that when oil and water are poured into the same container, they separate into two phases or layers, because they are immiscible.In general, aqueous (or water-based) solutions, being polar, are immiscible with non-polar organic solvents (cooking oil, chloroform, toluene, hexane etc.) and form a two-phase system.
Air is liquefied by the Linde process, in which air is alternately compressed, cooled, and expanded, each expansion results in a considerable reduction in temperature. With the lower temperature the molecules move more slowly and occupy less space, so the air changes phase to become liquid.
Super-absorbent polymers (SAP) similar to sodium polyacrylate were developed in the 1960s by the U.S. Department of Agriculture. [3] Before the development of these substances, the best water absorbing materials were cellulosic or fiber-based like tissue paper, sponge, cotton, or fluff pulp.
The reaction results in a polymer which is also soluble in the chosen solvent. Heat released by the reaction is absorbed by the solvent, reducing the reaction rate. Moreover, the viscosity of the reaction mixture is reduced, preventing autoacceleration at high monomer concentrations. A decrease in viscosity of the reaction mixture by dilution ...
A small amount of superabsorbent polymer material is taken (0.1g) and it is placed in the beaker. 100 ml of deionized water is poured into the beaker. After 20 min the swollen polymer was separated by using [filter paper] By weighing the polymer, one can find the swollen capacity of the SAP material. [3]
Chemists remove gases from solvents when the compounds they are working on are possibly air- or oxygen-sensitive (air-free technique), or when bubble formation at solid-liquid interfaces becomes a problem. The formation of gas bubbles when a liquid is frozen can also be undesirable, necessitating degassing beforehand.