Search results
Results from the WOW.Com Content Network
A male D-subminiature connector used for an RS-232 serial port on an IBM PC compatible computer along with the serial port symbol. A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1]
The most common usage is the DB25, using TASCAM's pinout (now standardised in AES59 by the Audio Engineering Society [1]). To avoid the possibility of bent pins on fixed equipment, the male connector is generally fitted to the cabling and the female connector to the equipment.
Pin No (DB25) Pin No (36 pin) Signal name Direction Register - bit Inverted 1 1 Strobe In/out Control-0 Yes 2 2 Data0 Out Data-0 No 3 3 Data1 Out Data-1 No 4 4 Data2 Out Data-2 No 5 5 Data3 Out Data-3 No 6 6 Data4 Out Data-4 No 7 7 Data5 Out Data-5 No 8 8 Data6 Out Data-6 No 9 9 Data7 Out Data-7 No 10 10 Ack In Status-6 No 11 11 Busy In Status-7
This file is licensed under the Creative Commons Attribution-Share Alike 3.0 Unported, 2.5 Generic, 2.0 Generic and 1.0 Generic license. You are free: to share – to copy, distribute and transmit the work
Male pinout of a 25-pin serial port (D-subminiature, DB-25) commonly found on 1980s computers. The following table lists commonly used RS-232 signals (called "circuits" in the specifications) and their pin assignments on the recommended DB-25 connectors [14] (see Serial port pinouts for other commonly used connectors not defined by the standard).
For example, DB-25 denotes a D-sub with a 25-position shell size and a 25-position contact configuration. The contacts in each row of these connectors are spaced 326/3000 of an inch apart, or approximately 0.1087 inches (2.76 mm), and the rows are spaced 0.112 inches (2.84 mm) apart; the pins in the two rows are offset by half the distance ...
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
The serial DCD pin can be used to accurately detect a PPS signal, as described in RFC 2783: [1] One convenient means to provide a PPS signal to a computer system is to connect that signal to a modem-control pin on a serial-line interface to the computer. The Data Carrier Detect (DCD) pin is frequently used for this purpose.