Search results
Results from the WOW.Com Content Network
A power-on self-test (POST) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on. [ 1 ] POST processes may set the initial state of the device from firmware and detect if any hardware components are non-functional.
Gigabyte developed the world's first software-controlled power supply in July 2007. [9] An innovative method to charge the iPad and iPhone on the computer was introduced by Gigabyte in April 2010. [10] Gigabyte launched the world's first Z68 motherboard on 31 May 2011, with an on-board mSATA connection for Intel SSD and Smart Response ...
cFosSpeed is a traffic shaping software often bundled with MSI motherboards for the Windows operating system. The program attaches itself as a device driver to the Windows network stack where it performs packet inspection and layer-7 protocol analysis. It has been noted as causing some issues with network connections, and can be difficult to ...
Using a standardized interface and protocol allows systems-management software based on IPMI to manage multiple, disparate servers. As a message-based, hardware-level interface specification, IPMI operates independently of the operating system (OS) to allow administrators to manage a system remotely in the absence of an operating system or of the system management software.
A case study of a LED based downlighter shows an example of the calculations done in order to calculate the required heat sink necessary for the effective cooling of lighting system. [22] The article also shows that in order to get confidence in the results, multiple independent solutions are required that give similar results.
The LED light sources sometimes used with multi-mode fiber produce a range of wavelengths and these each propagate at different speeds. This chromatic dispersion is another limit to the useful length for multi-mode fiber optic cable. In contrast, the lasers used to drive single-mode fibers produce coherent light of a single wavelength. Because ...
To output the movie the Spirit Datacine's Phantom Transfer Engine software running on an SGI computer is used to record the DPX files from the Spirit DataCine. These files are stored in the virtual telecine or on a SAN hard disk storage array. The Phantom Transfer Engine has been replaced with Bones software running on a Linux-based PC.
Phase-change memory uses different mechanical phases of phase-change material to store information in an X–Y addressable matrix and reads the information by observing the varying electrical resistance of the material. Phase-change memory would be non-volatile, random-access read/write storage, and might be used for primary, secondary and off ...