Search results
Results from the WOW.Com Content Network
A fishplate joins two lengths of track. A fishplate, splice bar or joint bar is a metal connecting plate used to bolt the ends of two rails into a continuous track. The name is derived from fish, [1] a wooden reinforcement of a "built-up" ship's mast that helped round out its desired profile. [2] The top and bottom faces taper inwards along ...
A splice joint is a method of joining two members end to end in woodworking. [1] The splice joint is used when the material being joined is not available in the length required. It is an alternative to other joints such as the butt joint and the scarf joint. Splice joints are stronger than unreinenforced butt joints and have the potential to be ...
Gusset plate. In structural engineering and construction, a gusset plate is a plate for connecting beams and girders to columns. A gusset plate can be fastened to a permanent member either by bolts, rivets or welding or a combination of the three. [1] They are used in bridges and buildings, as well as other structures.
Twist-on wire connectors. Twist-on wire connectors are a type of electrical connector used to fasten two or more low-voltage (or extra-low-voltage) electrical conductors. They are widely used in North America and several European countries in residential, commercial and industrial building power wiring, but have been banned in some other ...
Splice or butt connectors (primarily insulation displacement connectors) that permanently join two lengths of wire or cable. In computing, electrical connectors are considered a physical interface and constitute part of the physical layer in the OSI model of networking.
Earthing systems. v. t. e. Knob-and-tube wiring (sometimes abbreviated K&T) is an early standardized method of electrical wiring in buildings, in common use in North America from about 1880 to the 1930s. [1][2] It consisted of single-insulated copper conductors run within wall or ceiling cavities, passing through joist and stud drill-holes via ...
This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof. Trusses usually occur at regular intervals, linked by longitudinal timbers such as purlins. The space between each truss is known ...
The section of a key which enters a lock, which has the key cuts formed in it and which engages the bolt or tumblers of the lock. The bit is called a blade in the case of a cylinder key. [2] Bitting. The bitting of a key is the physical arrangement of the bit of the key that engage with the locking mechanism.