enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Pixel density - Wikipedia

    en.wikipedia.org/wiki/Pixel_density

    For example, a 100×100 pixel image printed in a 2 inch square has a resolution of 50 pixels per inch. Used this way, the measurement is meaningful when printing an image. In many applications, such as Adobe Photoshop, the program is designed so that one creates new images by specifying the output device and PPI (pixels per inch).

  3. Dots per inch - Wikipedia

    en.wikipedia.org/wiki/Dots_per_inch

    Thus, for example, a 10-point font on a Macintosh (at 72 PPI) was represented with 10 pixels (i.e., 10 PPEm), whereas a 10-point font on a Windows platform (at 96 PPI) at the same zoom level is represented with 13 pixels (i.e., Microsoft rounded 13 + 1 ⁄ 3 to 13 pixels, or 13 PPEm) – and, on a typical consumer grade monitor, would have ...

  4. Photo print sizes - Wikipedia

    en.wikipedia.org/wiki/Photo_print_sizes

    The alternative Super series, denoted SnR, nR Plus or nR+, has an aspect ratio of 3∶2 (or as close as possible) and thus provides a better fit for standard 135 film (35 mm) at sizes of 8 inches or above. 5R is twice the size of a 2R print, 6R twice the size of a 4R print and S8R twice the size of 6R. 4D/6D is a newer size for most consumer ...

  5. Dot pitch - Wikipedia

    en.wikipedia.org/wiki/Dot_pitch

    [1] [2] In the case of an RGB color display, the derived unit of pixel pitch is a measure of the size of a triad plus the distance between triads. Dot pitch may be measured in linear units (with smaller numbers meaning higher resolution), usually millimeters (mm), or as a rate, for example, dots per inch (with a larger number meaning higher ...

  6. Image resolution - Wikipedia

    en.wikipedia.org/wiki/Image_resolution

    An image that is 2048 pixels in width and 1536 pixels in height has a total of 2048×1536 = 3,145,728 pixels or 3.1 megapixels. One could refer to it as 2048 by 1536 or a 3.1-megapixel image. The image would be a very low quality image (72ppi) if printed at about 28.5 inches wide, but a very good quality (300ppi) image if printed at about 7 ...

  7. Image sensor format - Wikipedia

    en.wikipedia.org/wiki/Image_sensor_format

    Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.

  8. Image scaling - Wikipedia

    en.wikipedia.org/wiki/Image_scaling

    In the case of decreasing the pixel number (scaling down), this usually results in a visible quality loss. From the standpoint of digital signal processing, the scaling of raster graphics is a two-dimensional example of sample-rate conversion, the conversion of a discrete signal from a sampling rate (in this case, the local sampling rate) to ...

  9. JPEG File Interchange Format - Wikipedia

    en.wikipedia.org/wiki/JPEG_File_Interchange_Format

    Units for the following pixel density fields 00 : No units; width:height pixel aspect ratio = Ydensity:Xdensity; 01 : Pixels per inch (2.54 cm) 02 : Pixels per centimeter; Xdensity: 2: Horizontal pixel density. Must not be zero Ydensity: 2: Vertical pixel density. Must not be zero Xthumbnail: 1: Horizontal pixel count of the following embedded ...