enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. File:Power-supply-tester-diagram-2 26 13.pdf - Wikipedia

   en.wikipedia.org/wiki/File:Power-supply-tester...

   Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate

3. Power good signal - Wikipedia

   en.wikipedia.org/wiki/Power_good_signal

   The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).

4. ATX - Wikipedia

   en.wikipedia.org/wiki/ATX

   An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...

5. Power supply unit (computer) - Wikipedia

   en.wikipedia.org/wiki/Power_supply_unit_(computer)

   While an ATX power supply is connected to the mains supply, it always provides a 5-volt standby (5VSB) power so that the standby functions on the computer and certain peripherals are powered. ATX power supplies are turned on and off by a signal from the motherboard. They also provide a signal to the motherboard to indicate when the DC voltages ...

6. PS-ON Signal - Wikipedia

   en.wikipedia.org/wiki/PS-ON_Signal

   #PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).

7. Electrical outlet tester - Wikipedia

   en.wikipedia.org/wiki/Electrical_outlet_tester

   A receptacle tester being used to check for some types of improper wiring of an outlet. For this particular tester, proper wiring is indicated by the two yellow lights. The outlet tester checks that each contact in the outlet appears to be connected to the correct wire in the building's electrical wiring. It can identify several common wiring ...

8. Growler (electrical device) - Wikipedia

   en.wikipedia.org/wiki/Growler_(electrical_device)

   to test series and interpoles (commutating) fields from a DC motor; to determine phasing and polarity in multiwinding armatures; to test rotors in rotating frequency changers, as well as in wound rotors; to test shorts between turns in taped coils before installation into an armature or a stator; as a low voltage isolation transformer

9. LPX (form factor) - Wikipedia

   en.wikipedia.org/wiki/LPX_(form_factor)

   Because LPX form factor power supplies became ubiquitous in most computer cases prior to the ATX standard, it was not unusual for manufacturers to refer to them as "AT" power supplies (or occasionally as "PS/2" power supplies due to its use by the IBM PS/2), even though the actual AT and Baby AT power supply form factors were larger in size ...